VOLVO
ECM-1808 - Camshaft position (CMP) sensor / engine speed (RPM) sensor Faulty signal
System
Motorsteuergerät (ECM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
2 ModelleS40 (1996–2004), V40 (1996–2004)
Modelle nach Baujahr und Motor anzeigen (2)
Was bedeutet der Fehlercode?
The ECM compares the signal from the camshaft sensor with the signal from the engine speed sensor and checks that it lies within a reasonable range. If the camshaft sensor signal does not match what is expected, fault code ECM-1808 is set.
Mögliche Ursachen
- Signal wire short-circuited to voltage
- Signal wire short-circuited to ground
- Open circuit in the signal wire or the supply wire
- Camshaft or engine speed sensor incorrectly installed
- Defective camshaft position sensor
- Defective engine speed sensor
Was Sie tun können
- 1Switch off the ignition and check the camshaft sensor connector for play and oxidation
- 2With a multimeter, check that the signal wires from the camshaft and engine speed sensors have no break and are not shorted to ground or voltage
- 3Check that the camshaft and engine speed sensors are correctly mounted and not loose
- 4If you have a diagnostic tool: check in live data that the camshaft sensor signal follows engine speed with the engine idling
- 5If the fault remains, have a workshop replace the camshaft or engine speed sensor, depending on which is at fault
Symptome, die Sie bemerken können1
- The engine does not start
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.