VOLVO
ECM-180B - Accelerator pedal (AP) position sensor 2
System
Motorsteuergerät (ECM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
2 ModelleS40 (1996–2004), V40 (1996–2004)
Modelle nach Baujahr und Motor anzeigen (2)
Was bedeutet der Fehlercode?
The accelerator pedal has two sensors, and the ECM compares them with each other. The fault code for sensor 2 is set on a fault in its signal or supply wire, or if the difference between the sensors becomes too large. The engine is then controlled by sensor 1 instead.
Mögliche Ursachen
- Signal wire shorted to voltage or ground
- Open circuit in the signal wire
- Defective accelerator pedal position sensor
- Supply wire shorted to system voltage or ground
- Contact resistance or oxidation in the connector
- Defective engine control module
Was Sie tun können
- 1Switch off the ignition and check the pedal sensor connector for play, contact resistance and oxidation
- 2If you have a diagnostic tool: press the accelerator pedal fully down and release it straight away, and check in live data that sensor 2 follows sensor 1
- 3If the fault comes and goes, it may be oxidation or poor contact, and it can appear at any pedal position
- 4If the fault remains or is permanent, have a workshop replace the accelerator pedal position sensor
Symptome, die Sie bemerken können1
- No noticeable symptoms for the driver
Was der Fehler beeinflussen kann1
- The engine is controlled by pedal sensor 1 instead
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.