Zum Inhalt springen
    OBD Tuning
    SENDEN SIE AN UNS
    SENDEN SIE AN UNS
    Startseite
    Fehlercodes
    VOLVO
    ECM-254D
    VOLVO

    ECM-254D - Front heated oxygen sensor (HO2S), bank 2, heating. Signal too low

    System

    Motorsteuergerät (ECM)

    Volvo-Modelle, für die dieser Fehlercode gilt

    Gilt für folgende Modelle:

    2 Modelle

    S80 (1999–2006), XC90 (2003–)

    Modelle nach Baujahr und Motor anzeigen (2)
    • Volvo S80 (1999–2006)2005–2006Nur Motor: B6294S2, B6294T
    • Volvo XC90 (2003–)2005–2006Nur Motor: B6294T

    Was bedeutet der Fehlercode?

    The front oxygen sensor on bank 2 has an electric heater that the engine control module (ECM) controls with pulsed current. With the heating switched off, the signal should not fall below a certain value. If the ECM sees a signal that is too low in that state, the code is set.

    Mögliche Ursachen

    • Signal wire short-circuited to ground
    • Damaged front oxygen sensor on bank 2

    Was Sie tun können

    1. 1Read the code, clear it and road test the car to see whether it returns
    2. 2Check that the connector at the lambda sensor is fully engaged and free from moisture and oxidation. Do not use rust solvent spray or grease in the connector
    3. 3Use a multimeter to check that the signal wire has no contact with ground (chassis) when it is disconnected from the control module
    4. 4Look for chafed spots on the signal wire, where it may have been pinched or rubbed against a hot or sharp edge
    5. 5If the wire is intact and the connector is good the sensor may be damaged; have a workshop check it or replace it

    Symptome, die Sie bemerken können1

    • Malfunction indicator lamp (MIL) on

    Was der Fehler beeinflussen kann1

    • Oxygen sensor control is switched off

    Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.

    OBD Tuning

    Schwedens führendes Kompetenzzentrum für Automotorelektronik. Wir bieten professionelle ECU-Optimierung, Steuergerätereparatur und Diagnose mit 12-monatiger Garantie.

    Dienstleistungen

    • Motoroptimierung
    • ECU-Reparatur
    • Modul-Klonen
    • Kombiinstrument
    • SRS / Airbag
    • Wegfahrsperre

    Datenbank & Diagnose

    • ECU-Datenbank
    • DTC Fehlercodekatalog
    • Diagnoseanleitungen & Messwerte
    • KI-Fehlercode-Analysator
    • Neuigkeiten

    ECU-Hersteller

    • Bosch
    • Continental
    • Delphi
    • Delco
    • Denso
    • Magneti Marelli
    • Siemens / VDO
    • Keihin
    • Temic

    Unternehmen

    • Über uns
    • Kontakt
    • Workshop-Partner
    • Versandanleitung
    • Garantie
    • Häufig gestellte Fragen
    • AGB
    • Datenschutz
    • Sitemap

    • Motoroptimierung
    • ECU-Reparatur
    • Modul-Klonen
    • Kombiinstrument
    • SRS / Airbag
    • Wegfahrsperre

    • ECU-Datenbank
    • DTC Fehlercodekatalog
    • Diagnoseanleitungen & Messwerte
    • KI-Fehlercode-Analysator
    • Neuigkeiten

    • Bosch
    • Continental
    • Delphi
    • Delco
    • Denso
    • Magneti Marelli
    • Siemens / VDO
    • Keihin
    • Temic

    • Über uns
    • Kontakt
    • Workshop-Partner
    • Versandanleitung
    • Garantie
    • Häufig gestellte Fragen
    • AGB
    • Datenschutz
    • Sitemap

    Besuchen Sie uns

    Gjuterigatan 29, Karlstad

    Rufen Sie uns an

    054-830 480

    Schreiben Sie uns eine E-Mail

    service@obdtuning.se

    © 2026 OBD Tuning Karlstad. Alle Rechte vorbehalten.