VOLVO
ECM-2564 - Position sensor turbocharger (TC). Signal too low
System
Motorsteuergerät (ECM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
4 ModelleC30 (2007–2013), C70 (2006–2013), S40 (2004–2013), V50 (2004–2013)
Modelle nach Baujahr und Motor anzeigen (6)
- Volvo C30 (2007–2013)2007–2010Nur Motor: D4204T
- Volvo C70 (2006–2013)2008–2010Nur Motor: D4204T
- Volvo S40 (2004–2013)2004–2006Nur Motor: D4204T, D4204T2
- Volvo S40 (2004–2013)2007–2010Nur Motor: D4204T
- Volvo V50 (2004–2013)2004–2006Nur Motor: D4204T, D4204T2
- Volvo V50 (2004–2013)2007–2010Nur Motor: D4204T
Was bedeutet der Fehlercode?
The vacuum actuator on the turbocharger has a built-in position sensor that tells the engine control module (ECM) where the actuator is. If the sensor gives too low a signal, the ECM treats it as a fault and the code is set.
Mögliche Ursachen
- Contact resistance or oxidation in the connectors
- The signal wire is broken or shorted to ground
- The supply wire to the position sensor is broken or shorted to ground
- Damaged position sensor
Was Sie tun können
- 1Read the code, clear it and road test the car to see whether it returns
- 2Check that the connector to the position sensor on the vacuum actuator is secure and free from oxidation and contact resistance
- 3Use a multimeter to check that the signal and supply wires to the position sensor are not broken or shorted to ground
- 4With diagnostic equipment, read the position sensor value with the ignition on and check that it is stable
- 5Have a workshop replace or check the position sensor if the connectors and wiring are intact
Symptome, die Sie bemerken können1
- The malfunction indicator lamp (Check engine) lights up or behaves abnormally
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.