VOLVO
ECM-291C - Fuel pump control module. Signal too high
System
Motorsteuergerät (ECM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
9 ModelleC30 (2007–2013), C70 (2006–2013), S40 (2004–2013), S60 (2001–2009), S80 (1999–2006), V50 (2004–2013), V70 (2000–2008), V70 XC / XC70 (2001–2007), XC90 (2003–)
Modelle nach Baujahr und Motor anzeigen (23)
- Volvo C30 (2007–2013)2007Nur Motor: B5254T3
- Volvo C30 (2007–2013)2008–2013Nur Motor: B5254T7
- Volvo C70 (2006–2013)2006–2007Nur Motor: B5254T3
- Volvo C70 (2006–2013)2008–2013Nur Motor: B5254T7
- Volvo S40 (2004–2013)2005–2007Nur Motor: B5254T3
- Volvo S40 (2004–2013)2008Nur Motor: B5254T3, B5254T7
- Volvo S40 (2004–2013)2009–2012Nur Motor: B5254T7
- Volvo S60 (2001–2009)2005–2006Nur Motor: B5204T5, B5244T4, B5244T5, B5254T2, B5254T4
- Volvo S60 (2001–2009)2007Nur Motor: B5204T5, B5244T5, B5254T2, B5254T4
- Volvo S60 (2001–2009)2008–2009Nur Motor: B5204T5, B5244T5, B5254T2
- Volvo S80 (1999–2006)2005–2006Nur Motor: B5204T5, B5244T4, B5254T2, B6294S2, B6294T
- Volvo V50 (2004–2013)2005–2007Nur Motor: B5254T3
- Volvo V50 (2004–2013)2008–2012Nur Motor: B5254T7
- Volvo V70 (2000–2008)2005Nur Motor: B5204T5, B5244T4, B5244T5, B5254T2, B5254T4
- Volvo V70 (2000–2008)2006–2007Nur Motor: B5204T5, B5244T5, B5254T2, B5254T4
- Volvo V70 (2000–2008)2008Nur Motor: B5254T2
- Volvo V70 XC / XC70 (2001–2007)2005Alle Motoren außer: D5244T
- Volvo V70 XC / XC70 (2001–2007)2006Nur Motor: B5244T4, B5254T2
- Volvo V70 XC / XC70 (2001–2007)2007Nur Motor: B5254T2
- Volvo XC90 (2003–)2005–2006Nur Motor: B5254T2, B6294T
- Volvo XC90 (2003–)2007–2012Nur Motor: B5254T2
- Volvo XC90 (2003–)2013–2014Nur Motor: B5254T9
- Volvo XC90 (2003–)2015
Was bedeutet der Fehlercode?
The engine control module (ECM) requests fuel pressure from the fuel pump control module through a pulse width modulated (PWM) signal, and that module then drives the pump to match the request. The code is set when the signal between the two modules is too high. It can only be read while the engine is running.
Mögliche Ursachen
- Signal wire between the ECM and the fuel pump control module shorted to supply voltage
- Damaged fuel pump control module
- Damaged supply wire to the fuel pump control module
- Poor contact, oxidation or looseness in connectors and joints
- Damaged fuel pump or damaged ground connection to the pump
Was Sie tun können
- 1Find out whether the fault is permanent or intermittent; if the engine runs normally now, the fault is likely temporary
- 2Inspect the plugs at the fuel pump control module for oxidation and poor contact
- 3Check the power feed to the fuel pump control module and the pump itself, including the relay and fuse
- 4Check the ground connection to the pump control module and the fuel pump
- 5Read the codes in the central electronic module, as this code is often a knock-on effect of electrical faults, and check the signal wire with diagnostic equipment
Symptome, die Sie bemerken können5
- The engine does not start even though the starter motor turns
- The engine stalls
- Lack of power and poor performance, especially when starting off
- Jerky running, hesitation or surging on acceleration or deceleration
- Engine warning lamp (Check Engine) lit
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.