VOLVO
ECM-911C - Clutch pedal sensor. Signal too high
System
Motorsteuergerät (ECM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
4 ModelleC30 (2007–2013), C70 (2006–2013), S40 (2004–2013), V50 (2004–2013)
Modelle nach Baujahr und Motor anzeigen (9)
- Volvo C30 (2007–2013)2007Nur Motor: B5254T3
- Volvo C30 (2007–2013)2008–2013Nur Motor: B5254T7
- Volvo C70 (2006–2013)2006–2007Nur Motor: B5254T3
- Volvo C70 (2006–2013)2008–2013Nur Motor: B5254T7
- Volvo S40 (2004–2013)2005–2007Nur Motor: B5254T3
- Volvo S40 (2004–2013)2008Nur Motor: B5254T3, B5254T7
- Volvo S40 (2004–2013)2009–2012Nur Motor: B5254T7
- Volvo V50 (2004–2013)2005–2007Nur Motor: B5254T3
- Volvo V50 (2004–2013)2008–2012Nur Motor: B5254T7
Was bedeutet der Fehlercode?
The engine control module (ECM) has been sent an error report by the central electronic module (CEM) via CAN. It concerns a clutch pedal sensor that gives too high a signal, or a communication fault on the CAN network. There is no separate troubleshooting for this code, and it cannot be erased until the fault in the CEM is remedied.
Mögliche Ursachen
- Too high a signal from the clutch pedal sensor, reported by the CEM
- Fault in the communication on the CAN network
Was Sie tun können
- 1First remedy the fault codes in the central electronic module (CEM), as this code is set in the CEM first and then in the engine control module
- 2Erase the CEM fault codes once the cause is remedied, and then erase this code
- 3Check the connector at the clutch pedal sensor for loose contacts, oxidation and damage to the wiring
- 4If you have a diagnostic tool: read the clutch pedal position in live data and check that the value follows the pedal movement without jumps, from fully released to fully pressed
Symptome, die Sie bemerken können1
- The cruise control cannot be used at all
Was der Fehler beeinflussen kann1
- The cruise control is switched off
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.