Zum Inhalt springen
    OBD Tuning
    SENDEN SIE AN UNS
    SENDEN SIE AN UNS
    Startseite
    Fehlercodes
    VOLVO
    ECM-980F
    VOLVO

    ECM-980F - Air flow. Faulty flow

    System

    Motorsteuergerät (ECM)

    Volvo-Modelle, für die dieser Fehlercode gilt

    Gilt für folgende Modelle:

    7 Modelle

    C70 Cabriolet (1998–2005), C70 Coupé (1998–2002), S60 (2001–2009), S70 (1997–2000), S80 (1999–2006), V70 (1997–2000), V70 (2000–2008)

    Modelle nach Baujahr und Motor anzeigen (17)
    • Volvo C70 Cabriolet (1998–2005)2000Nur Motor: B5244S
    • Volvo C70 Coupé (1998–2002)2000Nur Motor: B5244S
    • Volvo S60 (2001–2009)2001Nur Motor: B5244S, B5244S2
    • Volvo S60 (2001–2009)2002Nur Motor: B5244S, B5244S2, B5244SG, B5244SG2
    • Volvo S60 (2001–2009)2003–2005Nur Motor: B5244SG, B5244SG2
    • Volvo S60 (2001–2009)2006–2008Nur Motor: B5244SG
    • Volvo S70 (1997–2000)2000Nur Motor: B5244S, B5244S2, B5244SG, B5244SG2
    • Volvo S80 (1999–2006)2000Nur Motor: B5244S, B5244S2
    • Volvo S80 (1999–2006)2001Nur Motor: B5244S, B5244S2, B5244SG
    • Volvo S80 (1999–2006)2002Nur Motor: B5244S, B5244S2, B5244SG, B5244SG2
    • Volvo S80 (1999–2006)2003–2005Nur Motor: B5244SG, B5244SG2
    • Volvo S80 (1999–2006)2006Nur Motor: B5244SG
    • Volvo V70 (1997–2000)2000Nur Motor: B5244S, B5244S2, B5244SG, B5244SG2
    • Volvo V70 (2000–2008)2001Nur Motor: B5244S, B5244S2, B5244SG
    • Volvo V70 (2000–2008)2002Nur Motor: B5244S, B5244S2, B5244SG, B5244SG2
    • Volvo V70 (2000–2008)2003–2005Nur Motor: B5244SG, B5244SG2
    • Volvo V70 (2000–2008)2006–2008Nur Motor: B5244SG

    Was bedeutet der Fehlercode?

    The ECM works out the air mass entering the engine from throttle position, engine speed, air temperature and atmospheric pressure, among other inputs. The calculated value is compared with the signals from the air mass meter and the intake pressure sensor. If either sensor deviates enough, the code is stored.

    Mögliche Ursachen

    • Faulty signal from one of the sensors
    • Exhaust camshaft has slipped a tooth
    • Air leakage after the air mass meter
    • Defective intake manifold pressure sensor
    • Defective air mass meter
    • Defective engine control module

    Was Sie tun können

    1. 1Check for air leaks after the air mass meter, in the hoses and connections on the intake side
    2. 2If you have a diagnostic tool: read air mass and intake manifold pressure in live data at idle and when pressing the throttle; they should follow engine load
    3. 3Check that the air mass meter and the intake manifold pressure sensor are firmly fitted and have clean connectors
    4. 4If the exhaust camshaft may have slipped a tooth, have a workshop check the camshaft position against the crankshaft
    5. 5Uneven idle can come from the control module running on substitute values, which is not the same as a drivability fault that existed before. After repair: clear the code and test drive

    Symptome, die Sie bemerken können2

    • Uneven idle
    • Malfunction indicator lamp lit

    Was der Fehler beeinflussen kann3

    • The throttle closes under braking, and pedal input is ignored while the brake is pressed
    • Cruise control is switched off for the driving cycle in which the fault was detected
    • Engine speed is limited by fuel cut-off and capped at a low value

    Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.

    OBD Tuning

    Schwedens führendes Kompetenzzentrum für Automotorelektronik. Wir bieten professionelle ECU-Optimierung, Steuergerätereparatur und Diagnose mit 12-monatiger Garantie.

    Dienstleistungen

    • Motoroptimierung
    • ECU-Reparatur
    • Modul-Klonen
    • Kombiinstrument
    • SRS / Airbag
    • Wegfahrsperre

    Datenbank & Diagnose

    • ECU-Datenbank
    • DTC Fehlercodekatalog
    • Diagnoseanleitungen & Messwerte
    • KI-Fehlercode-Analysator
    • Neuigkeiten

    ECU-Hersteller

    • Bosch
    • Continental
    • Delphi
    • Delco
    • Denso
    • Magneti Marelli
    • Siemens / VDO
    • Keihin
    • Temic

    Unternehmen

    • Über uns
    • Kontakt
    • Workshop-Partner
    • Versandanleitung
    • Garantie
    • Häufig gestellte Fragen
    • AGB
    • Datenschutz
    • Sitemap

    • Motoroptimierung
    • ECU-Reparatur
    • Modul-Klonen
    • Kombiinstrument
    • SRS / Airbag
    • Wegfahrsperre

    • ECU-Datenbank
    • DTC Fehlercodekatalog
    • Diagnoseanleitungen & Messwerte
    • KI-Fehlercode-Analysator
    • Neuigkeiten

    • Bosch
    • Continental
    • Delphi
    • Delco
    • Denso
    • Magneti Marelli
    • Siemens / VDO
    • Keihin
    • Temic

    • Über uns
    • Kontakt
    • Workshop-Partner
    • Versandanleitung
    • Garantie
    • Häufig gestellte Fragen
    • AGB
    • Datenschutz
    • Sitemap

    Besuchen Sie uns

    Gjuterigatan 29, Karlstad

    Rufen Sie uns an

    054-830 480

    Schreiben Sie uns eine E-Mail

    service@obdtuning.se

    © 2026 OBD Tuning Karlstad. Alle Rechte vorbehalten.