VOLVO
ECM-C073 - Control module, communication fault. Signal missing
System
Motorsteuergerät (ECM)
Volvo-Modelle, für die dieser Fehlercode gilt
Dieser Fehlercode hat je nach Modell, Modelljahr oder Motor unterschiedliche Bedeutungen. Wählen Sie die Bedeutung, die für Ihr Fahrzeug gilt.
Gilt für folgende Modelle:
4 ModelleC30 (2007–2013), C70 (2006–2013), S40 (2004–2013), V50 (2004–2013)
Modelle nach Baujahr und Motor anzeigen (6)
- Volvo C30 (2007–2013)2007–2010Nur Motor: D4204T
- Volvo C70 (2006–2013)2008–2010Nur Motor: D4204T
- Volvo S40 (2004–2013)2004–2006Nur Motor: D4204T, D4204T2
- Volvo S40 (2004–2013)2007–2010Nur Motor: D4204T
- Volvo V50 (2004–2013)2004–2006Nur Motor: D4204T, D4204T2
- Volvo V50 (2004–2013)2007–2010Nur Motor: D4204T
Was bedeutet der Fehlercode?
The code indicates that the engine control module is missing a signal from other control modules. It registers a serious disturbance on the high speed side of the CAN network, and then communication with the module is not possible. The engine control module shuts down and only restarts once the power supply is broken and reconnected.
Mögliche Ursachen
- Contact resistance or oxidation in the connections
- Open circuit in one of the CAN wires
- Short circuit between the CAN wires
- Internal fault in the engine control module
- Internal fault in another control module on the same section of the CAN network
Was Sie tun können
- 1Start by reading the fault codes from the CEM and the other affected modules. Do not erase the engine control module code until the others have been fixed
- 2Check that the battery is connected and that the fuses are intact
- 3Check the connectors at the engine control module and the CEM for corrosion, loose contacts and damage
- 4Look for chafing or pinched sections along the CAN wires
- 5If a control module stays in limp-home mode after the ignition is switched off and on, disconnect and reconnect the battery negative terminal
- 6If the fault remains, have a workshop measure the resistance and traffic load of the CAN network with diagnostic equipment
Symptome, die Sie bemerken können2
- A warning message or warning symbol appears in the display
- The Check engine warning lamp lights up or behaves abnormally
Was der Fehler beeinflussen kann2
- The engine control module switches itself off (bus-off)
- The engine control module stays off until the power supply is broken, and tries to communicate again when it is powered
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.