Was bedeutet der Fehlercode ECM-E010?

Diagnose und Fehlercodedefinition für ECM-E010 (Volvo C30 (2007–2013), Volvo S40 (2004–2013), Volvo V50 (2004–2013)). Steuergerätereparatur bei OBD Tuning.

VOLVO

ECM-E010 - Configuration problem. Software error

System

Motorsteuergerät (ECM)

Volvo-Modelle, für die dieser Fehlercode gilt

Gilt für folgende Modelle:

3 Modelle

C30 (2007–2013), S40 (2004–2013), V50 (2004–2013)

Modelle nach Baujahr und Motor anzeigen (3)

Was bedeutet der Fehlercode?

The engine control module checks its own ID against the setup the CEM broadcasts on CAN. The fault code is set when the IDs do not match, or when communication with the CEM is interrupted. The module then responds only to diagnostic commands and cannot communicate normally on CAN.

Mögliche Ursachen

Incorrect CAN configuration ID, because the engine control module is not intended for the car, for example a used unit with other software or hardware
Break in the CAN wiring between the engine control module and the CEM

Was Sie tun können

1If the engine control module has been replaced, check that it is intended for this car. Loading or programming software is workshop work
2Read out the fault codes in the CEM first, since fault-tracing starts there
3Check that the battery is connected and that the fuses are intact
4Look for breaks and chafing on the CAN wires between the engine control module and the CEM
5Erase the fault code once the faults are fixed, then road test the car to see whether it returns
6If the fault remains, have a workshop check the configuration and download new software if needed

Symptome, die Sie bemerken können5

General warning lamp lit
A message appears in the display
Cruise control is inoperative
Automatic engine start/stop does not work, both while driving and at idle
Autostart does not work

Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.