VOLVO
ECM-P001762 - Crankshaft Position - Camshaft Position Correlation - Bank 1 Sensor B. Algorithm Based Failures. Signal compare failure
System
Motorsteuergerät (ECM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
3 ModelleS60 (2011–), S80 (2007–), V70 (2008–)
Modelle nach Baujahr und Motor anzeigen (9)
- Volvo S60 (2011–)2011–2012Nur Motor: B5254T5
- Volvo S80 (2007–)2007–2008Nur Motor: B5254T6
- Volvo S80 (2007–)2009Nur Motor: B5254T6, B5254T8
- Volvo S80 (2007–)2010–2011Nur Motor: B5254T10, B5254T11, B5254T8
- Volvo S80 (2007–)2012Nur Motor: B5254T10
- Volvo V70 (2008–)2008Nur Motor: B5254T6
- Volvo V70 (2008–)2009Nur Motor: B5254T6, B5254T8
- Volvo V70 (2008–)2010–2011Nur Motor: B5254T10, B5254T11
- Volvo V70 (2008–)2012Nur Motor: B5254T10
Was bedeutet der Fehlercode?
The engine control module checks the camshaft positions relative to the crankshaft. The code concerns the exhaust camshaft, bank 1, sensor B, when it sits too far ahead of the crankshaft and the adaptation rises above a certain value. It is checked with the engine warm and idling, and it is an algorithm fault in comparing the signals.
Mögliche Ursachen
- Poor quality engine oil
- Incorrectly set camshafts
- Camshaft timing belt has skipped teeth
- Sticking camshaft control valve
- Mechanical fault in the VVT unit
- Damaged camshaft control valve
Was Sie tun können
- 1Read the code, clear it and road test the car to see whether it returns
- 2Check the engine oil level and quality, especially if the car mostly makes short trips, as fuel can then mix with the oil
- 3If you have a diagnostic tool: read the exhaust camshaft adaptation in live data with the engine warm and idling, and compare with the target value
- 4Have a workshop check the camshaft basic setting and the timing belt
- 5Have a workshop clean the camshaft control valve and check the oil passages in the cylinder head
- 6If the fault returns: have a workshop try a new control valve and check the VVT unit
Symptome, die Sie bemerken können5
- Check engine lamp lit or behaving abnormally
- The car lacks power
- Engine is hard to start and cranks slowly
- Engine hesitates or runs jerkily
- Emissions warning lamp lit
Was der Fehler beeinflussen kann1
- Camshaft control is switched off
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.