Was bedeutet der Fehlercode ECM-P001F00?

Diagnose und Fehlercodedefinition für ECM-P001F00 (Volvo S80 (2007–), Volvo S80 (2007–), Volvo V70 (2008–)). Steuergerätereparatur bei OBD Tuning.

VOLVO

ECM-P001F00 - Intake (A) Cam Profile Control Circuit High (Bank 2). General Failure Information. No sub type information

System

Motorsteuergerät (ECM)

Volvo-Modelle, für die dieser Fehlercode gilt

Gilt für folgende Modelle:

5 Modelle

S80 (2007–), V70 (2008–), XC60 (2009–), XC70 (2008–), XC90 (2003–)

Modelle nach Baujahr und Motor anzeigen (10)

Was bedeutet der Fehlercode?

The engine control module checks the control signal to the cam profile valves on the intake side, bank 2, and controls the variable cam profiles. The code is set when the control signal is too high, and it is tested with the ignition on. It is a general fault with no more specific description.

Mögliche Ursachen

Dirty or damaged cam profile solenoid
Signal wire shorted to supply voltage

Was Sie tun können

1Read the code, clear it and road test the car to see whether it returns
2Use a multimeter to check that the signal wire to the bank 2 solenoid is not shorted to supply voltage
3Check the connector at the solenoid for loose or corroded parts
4Have a workshop clean the cam profile solenoid, since metal casting residue in the oil can make it stick
5If you have a diagnostic tool: read the fault status once the diagnosis is complete, where it should show that no fault is found
6If the fault returns: have a workshop replace the cam profile solenoid if it still malfunctions after two cleanings

Symptome, die Sie bemerken können5

Emissions warning lamp lit
Uneven idle
Engine is hard to start
Higher fuel consumption
Reduced performance

Was der Fehler beeinflussen kann1

The variable cam profile on both banks switches to the low-lift position

Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.