VOLVO
ECM-P002626 - Intake Valve Control Solenoid Circuit Range/Performance (Bank 1). General Signal Failures. Signal rate of change below threshold
System
Motorsteuergerät (ECM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
3 ModelleS60 (2011–), S80 (2007–), V70 (2008–)
Modelle nach Baujahr und Motor anzeigen (9)
- Volvo S60 (2011–)2011–2012Nur Motor: B5254T5
- Volvo S80 (2007–)2007–2008Nur Motor: B5254T6
- Volvo S80 (2007–)2009Nur Motor: B5254T6, B5254T8
- Volvo S80 (2007–)2010–2011Nur Motor: B5254T10, B5254T11, B5254T8
- Volvo S80 (2007–)2012Nur Motor: B5254T10
- Volvo V70 (2008–)2008Nur Motor: B5254T6
- Volvo V70 (2008–)2009Nur Motor: B5254T6, B5254T8
- Volvo V70 (2008–)2010–2011Nur Motor: B5254T10, B5254T11
- Volvo V70 (2008–)2012Nur Motor: B5254T10
Was bedeutet der Fehlercode?
The code concerns the control solenoid for the intake valve on bank 1. The engine control module monitors the intake camshaft position and sets the code when the camshaft is not in the commanded position and the solenoid signal changes too slowly. The code is tested when the engine is running and camshaft control is active.
Mögliche Ursachen
- Low engine oil pressure
- Poor quality engine oil
- Sticking camshaft control valve
- Mechanical fault in the VVT unit
Was Sie tun können
- 1Read the code, clear it and road test the car to see whether it returns
- 2Check the fuse for the supply voltage to the intake camshaft control valve
- 3Check the engine oil level and quality, especially for contamination
- 4Have a workshop measure the oil pressure, since low pressure can cause the fault
- 5If you have a diagnostic tool: activate camshaft control and check that it responds
- 6If the fault returns: have a workshop clean the control valve, or replace it if cleaning does not help
Symptome, die Sie bemerken können4
- Check engine lamp lit or behaving abnormally
- Engine is hard to start and cranks slowly
- The car lacks power
- Engine hesitates or runs jerkily on acceleration and at steady speed
Was der Fehler beeinflussen kann1
- Camshaft control is switched off
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.