VOLVO
ECM-P003C00 - Intake (A) Camshaft Profile Control Performance or Stuck Off (Bank 1). General Failure Information. No sub type information
System
Motorsteuergerät (ECM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
5 ModelleS80 (2007–), V70 (2008–), XC60 (2009–), XC70 (2008–), XC90 (2003–)
Modelle nach Baujahr und Motor anzeigen (10)
- Volvo S80 (2007–)2007–2010Nur Motor: B6324S
- Volvo S80 (2007–)2011–2015Nur Motor: B6324S5
- Volvo V70 (2008–)2008–2010Nur Motor: B6324S
- Volvo V70 (2008–)2011–2014Nur Motor: B6324S5
- Volvo XC60 (2009–)2010Nur Motor: B6324S
- Volvo XC60 (2009–)2011–2015Nur Motor: B6324S5
- Volvo XC70 (2008–)2008–2010Nur Motor: B6324S
- Volvo XC70 (2008–)2011–2015Nur Motor: B6324S5
- Volvo XC90 (2003–)2007–2010Nur Motor: B6324S
- Volvo XC90 (2003–)2011–2014Nur Motor: B6324S5
Was bedeutet der Fehlercode?
The variable intake cam profile is controlled by one valve per bank. Here the intake manifold pressure is higher than expected for bank 1, which in this function covers cylinders 1, 2 and 4.
Mögliche Ursachen
- Dirty or damaged cam profile solenoid
- Blocked oil passages for the variable cam profile
Was Sie tun können
- 1Read the fault code with a diagnostic tool and note whether it is active now or only stored
- 2If you have a diagnostic tool, activate the cam profile solenoid for bank 1 and see whether it responds
- 3Check the connector and wiring to the bank 1 solenoid for looseness, corrosion and damage
- 4Impurities or cast debris in the oil can make the solenoid stick. Cleaning is usually enough, but a workshop should do it because the solenoid has to be removed
- 5Replace the solenoid if the fault remains after two cleanings
Symptome, die Sie bemerken können4
- Malfunction indicator lamp (MIL) lights up
- Uneven idle
- Engine is hard to start
- Poor performance
Was der Fehler beeinflussen kann1
- Both banks of the variable cam profile end up in low lift
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.