ECM-P00D000
VOLVO
ECM-P00D000 - Barometric Pressure - Turbocharger/Supercharger Boost Sensor "B" Correlation. General Failure Information. No sub type information
System
Motorsteuergerät (ECM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
8 ModelleS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Modelle nach Baujahr und Motor anzeigen (8)
- Volvo S60 (2011–)2014–2015Nur Motor: B4204T10, B4204T11, B4204T12, B4204T15, B4204T9
- Volvo S80 (2007–)2014–2015Nur Motor: B4204T11, B4204T12, B4204T15
- Volvo V40 (2013–)2015Nur Motor: B4204T11
- Volvo V40 Cross Country (2013–)2015Nur Motor: B4204T11
- Volvo V60 (2011–)2014–2015Nur Motor: B4204T11, B4204T12, B4204T15, B4204T9
- Volvo V70 (2008–)2014–2015Nur Motor: B4204T11
- Volvo XC60 (2009–)2014–2015Nur Motor: B4204T10, B4204T11, B4204T12, B4204T15, B4204T9
- Volvo XC70 (2008–)2014–2015Nur Motor: B4204T11
Was bedeutet der Fehlercode?
The ECM compares the filtered boost pressure signal with the reading from the barometric pressure sensor inside the control module. The code is stored when the difference between them is too large, and When the fault is present the control module replaces the boost reading with the barometric value, which switches off the compressor and reduces performance at low engine speeds.
Mögliche Ursachen
- Contact resistance or corrosion in the connections
- Open circuit in the signal or ground wire
- Boost pressure sensor is damaged
Was Sie tun können
- 1Read and note the code, clear it and road test to see whether it returns
- 2Check that the connector at boost pressure sensor B is fully engaged and free from corrosion and moisture
- 3Look for chafed or broken wiring to the sensor, especially where it bends
- 4With a multimeter, check that the signal and ground wires to the sensor have continuity
- 5If you have diagnostic equipment, compare boost sensor B with the barometric reading in live data at idle
- 6If the fault remains, have a workshop check the sensor and replace it if it is damaged
Symptome, die Sie bemerken können2
- Engine warning lamp (check engine) lit or behaving abnormally
- The car lacks power and runs poorly
Was der Fehler beeinflussen kann3
- The compressor is switched off
- The boost value is replaced by the barometric pressure reading
- Performance drops at low engine speeds
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.