VOLVO
ECM-P010124 - Mass or Volume Air Flow Sensor "A" Circuit Range/Performance. General Signal Failures. Signal stuck high
System
Motorsteuergerät (ECM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
1 ModellS60 (2011–)
Modelle nach Baujahr und Motor anzeigen (1)
Was bedeutet der Fehlercode?
The ECM compares the calculated air mass with the reading from the mass air flow sensor. If the correction factor becomes too low and the lambda adaptation sits above or below a fixed figure, the code is stored. The fault concerns a signal that stays at a constant high level, and among the results are calculated values for boost pressure and air mass.
Mögliche Ursachen
- Oxidised or high-resistance connector terminals at the mass air flow sensor
- Leak in the intake air system
- Obstructed intake system
- Damaged mass air flow sensor
Was Sie tun können
- 1Read and note the code, clear it and road test to see whether it returns
- 2Check the connector at the mass air flow sensor for oxidation and make sure it is firmly seated
- 3Look for leaks in the hoses and joints between the mass air flow sensor and the throttle body
- 4Look for obstructions in the intake system, such as dirt on the throttle
- 5Have a workshop check the mass air flow sensor if the fault persists once the intake has been checked
Symptome, die Sie bemerken können1
- Eco indicator lamp lit
Was der Fehler beeinflussen kann3
- The control module uses calculated boost pressure and calculated air mass
- Rear lambda sensor regulation is disabled
- Misfire diagnosis is disabled
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.