VOLVO
ECM-P012023 - Throttle/Pedal Position Sensor A Circuit. General Signal Failures. Signal stuck low
System
Motorsteuergerät (ECM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
7 ModelleS60 (2011–), S80 (2007–), V60 (2011–), V70 (2008–), XC60 (2009–), XC70 (2008–), XC90 (2003–)
Modelle nach Baujahr und Motor anzeigen (12)
- Volvo S60 (2011–)2011–2014Nur Motor: B6304T4
- Volvo S60 (2011–)2015Nur Motor: B6304T3, B6304T4, B6304T5
- Volvo S80 (2007–)2007Nur Motor: B6324S, B8444S
- Volvo S80 (2007–)2008–2009Nur Motor: B6304T2, B6324S, B8444S
- Volvo V60 (2011–)2011–2014Nur Motor: B6304T4
- Volvo V60 (2011–)2015Nur Motor: B6304T3, B6304T4, B6304T5
- Volvo V70 (2008–)2008–2009Nur Motor: B6304T2, B6324S
- Volvo XC60 (2009–)2009–2010Nur Motor: B6304T2
- Volvo XC60 (2009–)2011–2015Nur Motor: B6304T4
- Volvo XC70 (2008–)2008Nur Motor: B6324S
- Volvo XC70 (2008–)2009Nur Motor: B6304T2, B6324S
- Volvo XC90 (2003–)2007–2010Nur Motor: B6324S
Was bedeutet der Fehlercode?
The control module checks the PWM signal from the accelerator pedal position sensor. The fault code is set when that signal is too low for a set period of time.
Mögliche Ursachen
- Short-circuit to ground in the signal cable
- Damaged accelerator pedal position sensor
Was Sie tun können
- 1Read the fault code status with the ignition on and check whether the fault is active. Then clear the code and road test the vehicle
- 2Check the connector at the accelerator pedal for contact resistance and oxidation
- 3With the connector unplugged, use a multimeter to check that the signal cable is not short-circuited to ground
- 4If you have a diagnostic tool: read the pedal position in live data while pressing the pedal. A position that does not follow the pedal suggests the fault is still present
- 5If the connector and wiring are in order and the fault remains, have a workshop check or replace the accelerator pedal position sensor
Symptome, die Sie bemerken können2
- A message is shown in the information display
- The accelerator pedal is ignored during braking
Was der Fehler beeinflussen kann2
- The control module uses the analogue signal via CAN instead
- If the brake is pressed at the same time, the pedal position used is the released position
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.