VOLVO
ECM-P013016 - O2 Sensor Circuit (Bank 1 Sensor 1). General Electrical Failures. Circuit voltage below threshold
System
Motorsteuergerät (ECM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
8 ModelleS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Modelle nach Baujahr und Motor anzeigen (8)
- Volvo S60 (2011–)2014–2015Nur Motor: D4204T5
- Volvo S80 (2007–)2014–2015Nur Motor: D4204T5
- Volvo V40 (2013–)2015Nur Motor: D4204T14
- Volvo V40 Cross Country (2013–)2015Nur Motor: D4204T14
- Volvo V60 (2011–)2014–2015Nur Motor: D4204T5
- Volvo V70 (2008–)2014–2015Nur Motor: D4204T5
- Volvo XC60 (2009–)2014–2015Nur Motor: D4204T5
- Volvo XC70 (2008–)2014–2015Nur Motor: D4204T5
Was bedeutet der Fehlercode?
This code concerns the bank 1, sensor 1 oxygen sensor circuit, where the voltage is too low. The code can be set during engine braking with the accelerator released.
Mögliche Ursachen
- Damaged heated oxygen sensor (HO2S)
Was Sie tun können
- 1Read the fault code status with the ignition on and check whether the fault is active. Then clear the code and road test the vehicle
- 2Check the connector at the oxygen sensor for contact resistance and oxidation
- 3With the connector unplugged, use a multimeter to check that the wires to the oxygen sensor are not open-circuited or short-circuited to ground
- 4If the connector is in order and the fault remains, have a workshop check or replace the oxygen sensor
Symptome, die Sie bemerken können1
- The Check engine light comes on or behaves abnormally
Was der Fehler beeinflussen kann1
- The control module uses a calculated value instead of the oxygen sensor signal
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.