Was bedeutet der Fehlercode ECM-P013322?

Diagnose und Fehlercodedefinition für ECM-P013322 (Volvo S60 (2011–), Volvo S60 (2011–), Volvo S80 (2007–)). Steuergerätereparatur bei OBD Tuning.

VOLVO

ECM-P013322 - O2 Sensor Circuit Slow Response (Bank 1 Sensor 1). General Signal Failures. Signal too high

System

Motorsteuergerät (ECM)

Volvo-Modelle, für die dieser Fehlercode gilt

Gilt für folgende Modelle:

5 Modelle

S60 (2011–), S80 (2007–), V60 (2011–), V70 (2008–), XC60 (2009–)

Modelle nach Baujahr und Motor anzeigen (12)

Was bedeutet der Fehlercode?

Although the code is named for a high signal from the front oxygen sensor in bank 1, it is set when the sensor responds too slowly as the mixture changes. The ECM checks the sensor's wear by measuring how quickly it responds. The test only runs while driving, and the code is only stored once the ECM has started the test and the conditions for it have been met.

Mögliche Ursachen

Short circuit between the sensor's current-carrying wires
Open circuit in the sensor signal wire
Open circuit in the wire that supplies the sensor's calibration current
Damaged front oxygen sensor

Was Sie tun können

1Read the code, clear it and road test the car to see whether it comes back
2Clean soot and dirt from the connector and make sure it is fully engaged; do not use rust solvent spray or grease
3Use a multimeter to check the wires to the oxygen sensor for open circuits and for shorts to each other
4If you have a diagnostic tool: compare the oxygen sensor value in live data with the engine warm; it should change as the mixture switches between rich and lean
5If the fault remains after these checks, replace the front oxygen sensor

Symptome, die Sie bemerken können1

Check engine light (MIL) on

Was der Fehler beeinflussen kann1

Catalytic converter diagnostics are disabled

Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.