Zum Inhalt springen
    OBD Tuning
    SENDEN SIE AN UNS
    SENDEN SIE AN UNS
    Startseite
    Fehlercodes
    VOLVO
    ECM-P013600
    VOLVO

    ECM-P013600 - O2 Circuit (Bank 1, Sensor 2). General Failure Information. No sub type information

    System

    Motorsteuergerät (ECM)

    Volvo-Modelle, für die dieser Fehlercode gilt

    Gilt für folgende Modelle:

    4 Modelle

    S60 (2011–), S80 (2007–), V70 (2008–), XC90 (2003–)

    Modelle nach Baujahr und Motor anzeigen (11)
    • Volvo S60 (2011–)2011–2012Nur Motor: B5254T5
    • Volvo S80 (2007–)2007Nur Motor: B5254T6
    • Volvo S80 (2007–)2008Nur Motor: B4204S3, B4204S4, B5254T6
    • Volvo S80 (2007–)2009Nur Motor: B4204S3, B4204S4, B5254T6, B5254T8
    • Volvo S80 (2007–)2010–2011Nur Motor: B4204S3, B4204S4, B5254T10, B5254T11, B5254T8
    • Volvo S80 (2007–)2012Nur Motor: B5254T10
    • Volvo V70 (2008–)2008Nur Motor: B4204S3, B4204S4, B5254T6
    • Volvo V70 (2008–)2009Nur Motor: B4204S3, B4204S4, B5254T6, B5254T8
    • Volvo V70 (2008–)2010–2011Nur Motor: B4204S3, B4204S4, B5254T10, B5254T11
    • Volvo V70 (2008–)2012Nur Motor: B5254T10
    • Volvo XC90 (2003–)2005–2011Nur Motor: B8444S

    Was bedeutet der Fehlercode?

    The engine control module (ECM) monitors the rear oxygen sensor in bank 1, which sits after the catalytic converter. It checks the sensor signal while driving and sets the code when the signal is outside its permitted range, or when the sensor's pre-heating voltage disturbs the signal. The test requires the heater to be active and the car to have had a fuel cut, for example during deceleration.

    Mögliche Ursachen

    • Contact resistance or oxidation in the connections
    • Damaged rear oxygen sensor
    • Open circuit in the signal wire
    • Signal wire shorted to ground
    • Signal wire shorted to supply voltage

    Was Sie tun können

    1. 1Read the code, clear it and road test the car to see whether it comes back
    2. 2Check the connector to the rear oxygen sensor for contact resistance and oxidation; do not use rust solvent spray or grease
    3. 3Use a multimeter to check that the signal wire from the rear sensor has no open circuit and is not shorted to ground or to voltage
    4. 4If you have a diagnostic tool: read the rear oxygen sensor signal in live data with the engine warm and check whether it responds to changes in throttle position
    5. 5If the connector and wire are intact, replace the rear oxygen sensor

    Symptome, die Sie bemerken können1

    • Check engine light (MIL) on

    Was der Fehler beeinflussen kann1

    • Control using the rear oxygen sensor is switched off

    Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.

    Häufige Fehlerkombinationen

    ECM-P013600
    ECM-P013800
    ECM-P014000

    ECM-P013600, ECM-P013800, ECM-P014000 Volvo T5 / T6 – Bakre Diagnoslambdasond

    VOLVO • 176 Analysen

    Alle Diagnosekombinationen ansehen
    OBD Tuning

    Schwedens führendes Kompetenzzentrum für Automotorelektronik. Wir bieten professionelle ECU-Optimierung, Steuergerätereparatur und Diagnose mit 12-monatiger Garantie.

    Dienstleistungen

    • Motoroptimierung
    • ECU-Reparatur
    • Modul-Klonen
    • Kombiinstrument
    • SRS / Airbag
    • Wegfahrsperre

    Datenbank & Diagnose

    • ECU-Datenbank
    • DTC Fehlercodekatalog
    • Diagnoseanleitungen & Messwerte
    • KI-Fehlercode-Analysator
    • Neuigkeiten

    ECU-Hersteller

    • Bosch
    • Continental
    • Delphi
    • Delco
    • Denso
    • Magneti Marelli
    • Siemens / VDO
    • Keihin
    • Temic

    Unternehmen

    • Über uns
    • Kontakt
    • Workshop-Partner
    • Versandanleitung
    • Garantie
    • Häufig gestellte Fragen
    • AGB
    • Datenschutz
    • Sitemap

    • Motoroptimierung
    • ECU-Reparatur
    • Modul-Klonen
    • Kombiinstrument
    • SRS / Airbag
    • Wegfahrsperre

    • ECU-Datenbank
    • DTC Fehlercodekatalog
    • Diagnoseanleitungen & Messwerte
    • KI-Fehlercode-Analysator
    • Neuigkeiten

    • Bosch
    • Continental
    • Delphi
    • Delco
    • Denso
    • Magneti Marelli
    • Siemens / VDO
    • Keihin
    • Temic

    • Über uns
    • Kontakt
    • Workshop-Partner
    • Versandanleitung
    • Garantie
    • Häufig gestellte Fragen
    • AGB
    • Datenschutz
    • Sitemap

    Besuchen Sie uns

    Gjuterigatan 29, Karlstad

    Rufen Sie uns an

    054-830 480

    Schreiben Sie uns eine E-Mail

    service@obdtuning.se

    © 2026 OBD Tuning Karlstad. Alle Rechte vorbehalten.