VOLVO
ECM-P013C00 - O2 Sensor Slow Response - Rich to Lean (Bank 2, Sensor 2). General Failure Information. No sub type information
System
Motorsteuergerät (ECM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
5 ModelleS80 (2007–), V70 (2008–), XC60 (2009–), XC70 (2008–), XC90 (2003–)
Modelle nach Baujahr und Motor anzeigen (12)
- Volvo S80 (2007–)2010Nur Motor: B6324S, B8444S
- Volvo S80 (2007–)2011Nur Motor: B6324S5, B8444S
- Volvo S80 (2007–)2012–2015Nur Motor: B6324S5
- Volvo V70 (2008–)2010Nur Motor: B6324S
- Volvo V70 (2008–)2011–2014Nur Motor: B6324S5
- Volvo XC60 (2009–)2010Nur Motor: B6324S
- Volvo XC60 (2009–)2011–2015Nur Motor: B6324S5
- Volvo XC70 (2008–)2010Nur Motor: B6324S
- Volvo XC70 (2008–)2011–2015Nur Motor: B6324S5
- Volvo XC90 (2003–)2010Nur Motor: B8444S
- Volvo XC90 (2003–)2011Nur Motor: B6324S5, B8444S
- Volvo XC90 (2003–)2012–2014Nur Motor: B6324S5
Was bedeutet der Fehlercode?
The ECM monitors the rear oxygen sensor in bank 2, which sits in the cylinder row furthest back, near the passenger compartment. The ECM switches between rich and lean mixture and compares how well the sensor signal follows the changes. The code is set when the sensor reacts too slowly at the switch from rich to lean, in certain driving cases with fuel cut-off.
Mögliche Ursachen
- Contact resistance or oxidation in the connections
- Damaged rear oxygen sensor
Was Sie tun können
- 1Read the code, clear it and road test the car to see whether it comes back
- 2Check the connector to the rear oxygen sensor in bank 2 for contact resistance and oxidation; do not use rust solvent spray or grease
- 3Use a multimeter to check that the wires to the sensor have no open circuit
- 4If the connector and wires are intact, replace the rear oxygen sensor in bank 2
Symptome, die Sie bemerken können1
- Check engine light (MIL) on
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.