VOLVO
ECM-P020600 - Cylinder 6 Injector Circuit / Open. General Failure Information. No sub type information
System
Motorsteuergerät (ECM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
7 ModelleS60 (2011–), S80 (2007–), V60 (2011–), V70 (2008–), XC60 (2009–), XC70 (2008–), XC90 (2003–)
Modelle nach Baujahr und Motor anzeigen (24)
- Volvo S60 (2011–)2011–2014Nur Motor: B6304T4
- Volvo S60 (2011–)2015Nur Motor: B6304T3, B6304T4, B6304T5
- Volvo S80 (2007–)2007Nur Motor: B6324S, B8444S
- Volvo S80 (2007–)2008–2009Nur Motor: B6304T2, B6324S, B8444S
- Volvo S80 (2007–)2010Nur Motor: B6304T2, B6324S, B6324S2, B8444S
- Volvo S80 (2007–)2011Nur Motor: B6304T4, B6324S4, B6324S5, B8444S
- Volvo S80 (2007–)2012–2015Nur Motor: B6304T4, B6324S4, B6324S5
- Volvo V60 (2011–)2011–2014Nur Motor: B6304T4
- Volvo V60 (2011–)2015Nur Motor: B6304T3, B6304T4, B6304T5
- Volvo V70 (2008–)2008–2009Nur Motor: B6304T2, B6324S
- Volvo V70 (2008–)2010Nur Motor: B6304T2, B6324S, B6324S2
- Volvo V70 (2008–)2011–2014Nur Motor: B6304T4, B6324S5
- Volvo V70 (2008–)2015Nur Motor: B6304T4
- Volvo XC60 (2009–)2009Nur Motor: B6304T2
- Volvo XC60 (2009–)2010Nur Motor: B6304T2, B6324S, B6324S2
- Volvo XC60 (2009–)2011–2015Nur Motor: B6304T4, B6324S4, B6324S5
- Volvo XC70 (2008–)2008Nur Motor: B6324S
- Volvo XC70 (2008–)2009Nur Motor: B6304T2, B6324S
- Volvo XC70 (2008–)2010Nur Motor: B6304T2, B6324S, B6324S2
- Volvo XC70 (2008–)2011–2015Nur Motor: B6304T4, B6324S4, B6324S5
- Volvo XC90 (2003–)2005–2006Nur Motor: B8444S
- Volvo XC90 (2003–)2007–2010Nur Motor: B6324S, B8444S
- Volvo XC90 (2003–)2011Nur Motor: B6324S5, B8444S
- Volvo XC90 (2003–)2012–2014Nur Motor: B6324S5
Was bedeutet der Fehlercode?
The control module (ECM) controls the injection timing for the injector on cylinder 6. The code is set when the control signal to the injector is out of range or absent, and lambda control is then blocked.
Mögliche Ursachen
- Contact resistance and oxidation in the injector connector
- Signal wire shorted to voltage
- Open circuit in the signal wire or the voltage supply wire
- Open circuit in the voltage supply wire
- Damaged injector
Was Sie tun können
- 1Check that the fuses are intact
- 2Read and clear the code, then start the engine to see whether it returns
- 3Check the connector to the injector on cylinder 6 for contact resistance and oxidation
- 4Use a multimeter to check that the wires to the injector on cylinder 6 have no break and are not shorted to voltage or earth
- 5If the fault remains, a workshop with diagnostic equipment should check the injector on cylinder 6 and the wires to it
Symptome, die Sie bemerken können5
- The environmental warning lamp lights up
- The engine does not run on all cylinders
- Cranking is fine, but the engine does not start
- The engine hesitates, surges or runs unevenly on acceleration or at steady speed
- Poor performance and lack of power
Was der Fehler beeinflussen kann1
- Lambda control is blocked
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.