VOLVO
ECM-P022082 - Throttle/Pedal Position Switch B Circuit. Bus Signal / Message Failures. Alive / sequence counter incorrect / not updated
System
Motorsteuergerät (ECM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
7 ModelleS60 (2011–), S80 (2007–), V60 (2011–), V70 (2008–), XC60 (2009–), XC70 (2008–), XC90 (2003–)
Modelle nach Baujahr und Motor anzeigen (12)
- Volvo S60 (2011–)2011–2014Nur Motor: B6304T4
- Volvo S60 (2011–)2015Nur Motor: B6304T3, B6304T4, B6304T5
- Volvo S80 (2007–)2007Nur Motor: B6324S, B8444S
- Volvo S80 (2007–)2008–2009Nur Motor: B6304T2, B6324S, B8444S
- Volvo V60 (2011–)2011–2014Nur Motor: B6304T4
- Volvo V60 (2011–)2015Nur Motor: B6304T3, B6304T4, B6304T5
- Volvo V70 (2008–)2008–2009Nur Motor: B6304T2, B6324S
- Volvo XC60 (2009–)2009–2010Nur Motor: B6304T2
- Volvo XC60 (2009–)2011–2015Nur Motor: B6304T4
- Volvo XC70 (2008–)2008Nur Motor: B6324S
- Volvo XC70 (2008–)2009Nur Motor: B6304T2, B6324S
- Volvo XC90 (2003–)2007–2010Nur Motor: B6324S
Was bedeutet der Fehlercode?
The engine control module (ECM) monitors communication with the central electronic module (CEM) on the CAN network, which carries the accelerator pedal position. The code means that messages from the CEM lack a correct sequence counter or are not being updated, that is, the counter that should change with each new message does not match. This points to a communication fault, for example in a wire or connector.
Mögliche Ursachen
- Open circuit in the communication wire
- Communication wire shorted to ground
- Communication wire shorted to supply voltage
- Contact resistance or oxidation in the connections
- Open circuit in the connections
- Short circuit in the connections
Was Sie tun können
- 1Read the codes in all control modules. Several codes at once often point to a communication fault on the CAN network
- 2Check that the battery is fully charged and that the battery terminals and earth connections are clean and tight
- 3Gently shake the wiring harness and connectors with the ignition on and see whether the fault appears. A loose connection may be the cause
- 4Check that the fuses are intact. Fuse locations are shown in the owner's manual
- 5Do not replace the central electronic module (CEM) for a CAN fault unless troubleshooting has shown that it is faulty
- 6Have a workshop measure on the CAN network with diagnostic equipment and find which control module is disrupting communication
Symptome, die Sie bemerken können2
- Message in the information display
- Accelerator pedal ignored when the brake is applied
Was der Fehler beeinflussen kann1
- When the brake pedal is pressed at the same time, the accelerator is treated as released
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.