VOLVO
ECM-P024E00 - Intercooler Bypass Valve Position Sensor, Circuit Low. General Failure Information. No sub type information
System
Motorsteuergerät (ECM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
2 ModelleS80 (2007–), V70 (2008–)
Modelle nach Baujahr und Motor anzeigen (2)
Was bedeutet der Fehlercode?
The engine control module (ECM) drives the bypass valve with a PWM signal. The fault is set when the control module registers a fault on that signal, or when the end stage for the valve becomes too hot. The end stage is built into the control module.
Mögliche Ursachen
- Loose contact, contact resistance or oxidation in the connections
- Signal wire shorted to ground
- Open circuit in the supply voltage
- Open circuit in the signal wire
- Damaged bypass valve
Was Sie tun können
- 1Read the code, clear it and road test to see whether it returns
- 2Check that the connector to the bypass valve is secure and clean
- 3Use a multimeter to check that the supply to the bypass valve is not broken
- 4If you have a diagnostic tool: activate the bypass valve and listen for it moving
- 5Check that the fuses are intact. Fuse locations are shown in the owner's manual
- 6If the fault remains, have a workshop check the bypass valve with diagnostic equipment
Symptome, die Sie bemerken können4
- The car feels poor to drive, with reduced performance and lack of power
- The car hesitates, surges or runs jerkily
- Warning symbol and text message in the display
- The check engine lamp comes on or behaves abnormally
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.