VOLVO
ECM-P025311 - Injection Pump Fuel Metering Control A Low. General Electrical Failures. Circuit short to ground
System
Motorsteuergerät (ECM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
7 ModelleS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V70 (2008–), XC60 (2009–)
Modelle nach Baujahr und Motor anzeigen (20)
- Volvo S60 (2011–)2011Nur Motor: B4164T, B4164T3, B4204T6, B4204T7
- Volvo S60 (2011–)2012–2014Nur Motor: B4164T, B4164T2, B4164T3, B4204T7
- Volvo S60 (2011–)2015Nur Motor: B4164T, B4164T2, B4164T3
- Volvo S80 (2007–)2010Nur Motor: B4204T6
- Volvo S80 (2007–)2011Nur Motor: B4164T, B4204T6, B4204T7
- Volvo S80 (2007–)2012–2014Nur Motor: B4164T, B4164T2, B4204T6, B4204T7
- Volvo S80 (2007–)2015Nur Motor: B4164T
- Volvo V40 (2013–)2013Nur Motor: B4164T, B4164T3
- Volvo V40 (2013–)2014–2015Nur Motor: B4164T, B4164T3, B4164T4
- Volvo V40 Cross Country (2013–)2013–2015Nur Motor: B4164T
- Volvo V60 (2011–)2011Nur Motor: B4164T, B4164T3, B4204T6, B4204T7
- Volvo V60 (2011–)2012–2014Nur Motor: B4164T, B4164T2, B4164T3, B4204T7
- Volvo V60 (2011–)2015Nur Motor: B4164T, B4164T2, B4164T3
- Volvo V70 (2008–)2010Nur Motor: B4204T6
- Volvo V70 (2008–)2011Nur Motor: B4164T, B4204T6, B4204T7
- Volvo V70 (2008–)2012–2014Nur Motor: B4164T, B4164T2, B4204T7
- Volvo V70 (2008–)2015Nur Motor: B4164T, B4164T2
- Volvo XC60 (2009–)2010Nur Motor: B4204T6
- Volvo XC60 (2009–)2011–2012Nur Motor: B4204T6, B4204T7
- Volvo XC60 (2009–)2013–2015Nur Motor: B4204T7
Was bedeutet der Fehlercode?
The engine control module (ECM) monitors the high-pressure side of the fuel system. The high-pressure fuel pump is activated when the ECM grounds the pump's ground lead. The code is stored when the ECM detects that this ground lead has been short-circuited to ground. It is a general electrical fault.
Mögliche Ursachen
- Contact resistance or oxidation in the connections
- Open circuit in the ground lead
- Ground lead short-circuited to ground
- Damaged fuel pump
Was Sie tun können
- 1Read and note the fault code, clear it and test drive to see whether it returns
- 2Check that the fuses are intact
- 3Check the ground connections to the fuel pump for contact resistance and oxidation
- 4With the ignition off and the connector disconnected, use a multimeter to check that the pump's ground lead has no open circuit and no contact with the body
- 5If you have a diagnostic tool: activate the high-pressure pump and listen for it to start
- 6Have a workshop check the fuel pump and its control
Symptome, die Sie bemerken können3
- The Check engine light comes on or behaves abnormally
- Uneven idle
- The car hesitates, surges or runs jerkily, at any time or all the time
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.