VOLVO
ECM-P027700 - Cylinder 6 Injector Circuit High. General Failure Information. No sub type information
System
Motorsteuergerät (ECM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
7 ModelleS60 (2011–), S80 (2007–), V60 (2011–), V70 (2008–), XC60 (2009–), XC70 (2008–), XC90 (2003–)
Modelle nach Baujahr und Motor anzeigen (10)
- Volvo S60 (2011–)2011–2014Nur Motor: B6304T4
- Volvo S60 (2011–)2015Nur Motor: B6304T3, B6304T4, B6304T5
- Volvo S80 (2007–)2011–2015Nur Motor: B6304T4, B6324S4, B6324S5
- Volvo V60 (2011–)2011–2014Nur Motor: B6304T4
- Volvo V60 (2011–)2015Nur Motor: B6304T3, B6304T4, B6304T5
- Volvo V70 (2008–)2011–2014Nur Motor: B6304T4, B6324S5
- Volvo V70 (2008–)2015Nur Motor: B6304T4
- Volvo XC60 (2009–)2011–2015Nur Motor: B6304T4, B6324S4, B6324S5
- Volvo XC70 (2008–)2011–2015Nur Motor: B6304T4, B6324S4, B6324S5
- Volvo XC90 (2003–)2011–2014Nur Motor: B6324S5
Was bedeutet der Fehlercode?
The ECM sets injection duration and timing by driving the injectors, and stores the code when the signal to the injector for cylinder 6 is too high. The code is general and does not say what type of fault it is. It applies to cylinder 6 only.
Mögliche Ursachen
- Signal wire short-circuited to supply voltage
- Damaged injector
Was Sie tun können
- 1Read and note the fault code, clear it and test drive to see whether it returns
- 2With the ignition on and the connector disconnected, use a multimeter to check whether the cylinder 6 signal wire has voltage to ground
- 3Check the connector to the cylinder 6 injector for contact resistance and oxidation
- 4Have a workshop with diagnostic equipment check the injector for cylinder 6 and its control
Symptome, die Sie bemerken können2
- The emissions warning lamp comes on
- The engine does not run on all cylinders
Was der Fehler beeinflussen kann1
- The control module blocks lambda control
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.