VOLVO
ECM-P032622 - Knock Sensor 1 Circuit Range/Performance (Bank 1). General Signal Failures. Signal too high
System
Motorsteuergerät (ECM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
10 ModelleS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V60 Cross Country (2015–), V70 (2008–), XC60 (2009–), XC70 (2008–), XC90 (2003–)
Modelle nach Baujahr und Motor anzeigen (32)
- Volvo S60 (2011–)2011–2012Nur Motor: B6304T4
- Volvo S60 (2011–)2013Nur Motor: B5204T8, B5204T9, B5254T12, B5254T14, B6304T4
- Volvo S60 (2011–)2014Nur Motor: B4204T10, B4204T11, B4204T12, B4204T15, B4204T9, B5204T8, B5204T9, B5254T12, B5254T14, B6304T4
- Volvo S60 (2011–)2015Alle Motoren außer: B4164T, B4164T2, B4164T3, D4162T, D4204T5, D5204T3, D5204T7, D5244T11, D5244T15, D5244T23
- Volvo S80 (2007–)2010Nur Motor: B6304T2, B6324S, B6324S2, B8444S
- Volvo S80 (2007–)2011Nur Motor: B6304T4, B6324S4, B6324S5, B8444S
- Volvo S80 (2007–)2012Nur Motor: B6304T4, B6324S4, B6324S5
- Volvo S80 (2007–)2013Nur Motor: B5254T12, B5254T14, B6304T4, B6324S4, B6324S5
- Volvo S80 (2007–)2014Nur Motor: B4204T11, B4204T12, B4204T15, B5254T12, B5254T14, B6304T4, B6324S4, B6324S5
- Volvo S80 (2007–)2015Alle Motoren außer: B4164T, D4162T, D4204T5, D5204T3, D5244T15
- Volvo V40 (2013–)2013–2014Nur Motor: B5204T8, B5204T9, B5254T12, B5254T14
- Volvo V40 (2013–)2015Nur Motor: B4204T11, B5204T8, B5204T9
- Volvo V40 Cross Country (2013–)2013–2014Nur Motor: B5204T8, B5204T9, B5254T12, B5254T14
- Volvo V40 Cross Country (2013–)2015Alle Motoren außer: B4164T, D4162T, D4204T14, D5204T6
- Volvo V60 (2011–)2011–2012Nur Motor: B6304T4
- Volvo V60 (2011–)2013Nur Motor: B5204T8, B5204T9, B6304T4
- Volvo V60 (2011–)2014Nur Motor: B4204T11, B4204T12, B4204T15, B4204T9, B5204T8, B5204T9, B5254T12, B6304T4
- Volvo V60 (2011–)2015Nur Motor: B4204T11, B4204T12, B4204T15, B4204T9, B5204T9, B5254T12, B6304T3, B6304T4, B6304T5
- Volvo V60 Cross Country (2015–)2015
- Volvo V70 (2008–)2010Nur Motor: B6304T2, B6324S, B6324S2
- Volvo V70 (2008–)2011–2012Nur Motor: B6304T4, B6324S5
- Volvo V70 (2008–)2013Nur Motor: B5204T9, B6304T4, B6324S5
- Volvo V70 (2008–)2014Nur Motor: B4204T11, B5204T9, B6304T4, B6324S5
- Volvo V70 (2008–)2015Nur Motor: B4204T11, B5204T9, B6304T4
- Volvo XC60 (2009–)2010Nur Motor: B6304T2, B6324S, B6324S2
- Volvo XC60 (2009–)2011–2013Nur Motor: B6304T4, B6324S4, B6324S5
- Volvo XC60 (2009–)2014Nur Motor: B4204T10, B4204T11, B4204T12, B4204T15, B4204T9, B6304T4, B6324S4, B6324S5
- Volvo XC60 (2009–)2015Alle Motoren außer: B4204T7, D4204T5, D5204T3, D5204T7, D5244T11, D5244T12, D5244T15, D5244T17, D5244T23
- Volvo XC70 (2008–)2010Nur Motor: B6304T2, B6324S, B6324S2
- Volvo XC70 (2008–)2011–2013Nur Motor: B6304T4, B6324S4, B6324S5
- Volvo XC70 (2008–)2014–2015Nur Motor: B4204T11, B6304T4, B6324S4, B6324S5
- Volvo XC90 (2003–)2011–2014Nur Motor: B6324S5
Was bedeutet der Fehlercode?
Knock sensor 1, which registers knock on cylinders 5 to 8, must give a signal within limits that change with engine speed. If the signal is higher than the permitted limit, the fault code is set. The causes are the same as for a signal that is too low: contact, a loose sensor or a damaged sensor.
Mögliche Ursachen
- Contact resistance or oxidation at the knock sensor plug
- Loose knock sensor
- Damaged knock sensor
Was Sie tun können
- 1Read the fault code, clear it and take a short drive to see whether it returns
- 2Check that the knock sensor is firmly fitted and has not moved
- 3Check the knock sensor plug for contact resistance and oxidation
- 4If you have a diagnostic tool: compare the knock signal in live data at idle and under throttle and see whether it becomes too high in either case
- 5Have a workshop with diagnostic equipment check and, if needed, replace the knock sensor
Symptome, die Sie bemerken können4
- Poor performance and lack of power, especially when pulling away from standstill
- The engine hesitates, surges or runs roughly during acceleration, slowing down and constant speed
- Reduced performance
- The Check engine light lights up or behaves abnormally
Was der Fehler beeinflussen kann2
- Ignition timing is retarded as a safety measure
- Knock control is disabled
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.