ECM-P035600
VOLVO
ECM-P035600 - Ignition Coil F Primary/Secondary Circuit. General Failure Information. No sub type information
System
Motorsteuergerät (ECM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
5 ModelleS80 (2007–), V70 (2008–), XC60 (2009–), XC70 (2008–), XC90 (2003–)
Modelle nach Baujahr und Motor anzeigen (13)
- Volvo S80 (2007–)2007Nur Motor: B6324S, B8444S
- Volvo S80 (2007–)2008–2009Nur Motor: B6304T2, B6324S, B8444S
- Volvo S80 (2007–)2010Nur Motor: B6304T2, B6324S, B6324S2, B8444S
- Volvo S80 (2007–)2011Nur Motor: B8444S
- Volvo V70 (2008–)2008–2009Nur Motor: B6304T2, B6324S
- Volvo V70 (2008–)2010Nur Motor: B6304T2, B6324S, B6324S2
- Volvo XC60 (2009–)2009Nur Motor: B6304T2
- Volvo XC60 (2009–)2010Nur Motor: B6304T2, B6324S, B6324S2
- Volvo XC70 (2008–)2008Nur Motor: B6324S
- Volvo XC70 (2008–)2009Nur Motor: B6304T2, B6324S
- Volvo XC70 (2008–)2010Nur Motor: B6304T2, B6324S, B6324S2
- Volvo XC90 (2003–)2005–2006, 2011Nur Motor: B8444S
- Volvo XC90 (2003–)2007–2010Nur Motor: B6324S, B8444S
Was bedeutet der Fehlercode?
The code applies to ignition coil F, which is the coil for cylinder 6. The engine control module (ECM) controls the coils and checks their signal through a separate diagnostic line. The code does not say which type of fault it is.
Mögliche Ursachen
- Contact resistance and oxidation at the coil connector
- Signal wire short circuit to ground or supply voltage
- Open circuit in the signal wire
- Open circuit in the supply wire
- Diagnostic line short circuit to ground or supply voltage
- Damaged ignition coil
Was Sie tun können
- 1If you have a diagnostic tool, start the engine and read the fault status. 'No fault found' means the fault is not active right now.
- 2Check that the fuses are intact.
- 3With the ignition off, check the connectors to the ignition coil for cylinder 6 for contact resistance and oxidation.
- 4Use a multimeter to check that the wires to the ignition coil for cylinder 6 have no open circuit and are not shorted to ground or supply voltage.
- 5Check that the ignition coil is secure and not damaged.
- 6If the fault returns, have a workshop test the ignition coil for cylinder 6 and the wires to it.
Symptome, die Sie bemerken können5
- Engine misfires
- Car lacks power, especially when pulling away from standstill
- Car lacks power while driving
- Car hesitates or jerks during acceleration
- Car hesitates or jerks when slowing down
Was der Fehler beeinflussen kann1
- Closed loop control of lambda is blocked
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.