VOLVO
ECM-P035612 - Ignition Coil F Primary/Secondary Circuit. General Electrical Failures. Circuit short to battery
System
Motorsteuergerät (ECM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
7 ModelleS60 (2011–), S80 (2007–), V60 (2011–), V70 (2008–), XC60 (2009–), XC70 (2008–), XC90 (2003–)
Modelle nach Baujahr und Motor anzeigen (10)
- Volvo S60 (2011–)2011–2014Nur Motor: B6304T4
- Volvo S60 (2011–)2015Nur Motor: B6304T3, B6304T4, B6304T5
- Volvo S80 (2007–)2011–2015Nur Motor: B6304T4, B6324S4, B6324S5
- Volvo V60 (2011–)2011–2014Nur Motor: B6304T4
- Volvo V60 (2011–)2015Nur Motor: B6304T3, B6304T4, B6304T5
- Volvo V70 (2008–)2011–2014Nur Motor: B6304T4, B6324S5
- Volvo V70 (2008–)2015Nur Motor: B6304T4
- Volvo XC60 (2009–)2011–2015Nur Motor: B6304T4, B6324S4, B6324S5
- Volvo XC70 (2008–)2011–2015Nur Motor: B6304T4, B6324S4, B6324S5
- Volvo XC90 (2003–)2011–2014Nur Motor: B6324S5
Was bedeutet der Fehlercode?
The signal wire between the engine control module (ECM) and ignition coil F is shorted to supply voltage. The code is stored when the incorrect value lasts longer than a set time and stays over two or more driving cycles in a row.
Mögliche Ursachen
- Contact resistance and oxidation in the connections
- Signal wire short circuit to supply voltage
- Damaged ignition coil
Was Sie tun können
- 1If you have a diagnostic tool, start the engine and read the fault status. 'No fault found' means the fault is not active right now.
- 2Check that the fuses are intact.
- 3With the ignition off, check that the connector at ignition coil F is secure and free from contact resistance and oxidation.
- 4Check that the signal wire to ignition coil F is not chafed or pinched so that it can touch supply voltage.
- 5Check that the ignition coil is secure and not damaged.
- 6If the fault returns, have a workshop measure at ignition coil F and its signal wire.
Symptome, die Sie bemerken können4
- Engine lacks power, especially when pulling away from standstill
- Engine lacks power while driving
- Engine hesitates or jerks when slowing down
- Engine hesitates or jerks at steady speed
Was der Fehler beeinflussen kann1
- Closed loop control of lambda is blocked
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.