VOLVO
ECM-P036700 - Camshaft Position Sensor B Circuit Low Input (Bank 1). General Failure Information. No sub type information
System
Motorsteuergerät (ECM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
3 ModelleS60 (2011–), S80 (2007–), V70 (2008–)
Modelle nach Baujahr und Motor anzeigen (9)
- Volvo S60 (2011–)2011–2012Nur Motor: B5254T5
- Volvo S80 (2007–)2007–2008Nur Motor: B5254T6
- Volvo S80 (2007–)2009Nur Motor: B5254T6, B5254T8
- Volvo S80 (2007–)2010–2011Nur Motor: B5254T10, B5254T11, B5254T8
- Volvo S80 (2007–)2012Nur Motor: B5254T10
- Volvo V70 (2008–)2008Nur Motor: B5254T6
- Volvo V70 (2008–)2009Nur Motor: B5254T6, B5254T8
- Volvo V70 (2008–)2010–2011Nur Motor: B5254T10, B5254T11
- Volvo V70 (2008–)2012Nur Motor: B5254T10
Was bedeutet der Fehlercode?
The signal from the exhaust camshaft sensor on bank 1 is held constantly low, which the engine control module (ECM) registers as a fault while the engine runs. The code does not say which type of fault it is.
Mögliche Ursachen
- Signal wire short circuit to ground
- Open circuit in the supply wire
- Loose connections
Was Sie tun können
- 1If you have a diagnostic tool, start the engine and read the fault status. 'Fault found' means the fault is permanent.
- 2Check that the fuses are intact.
- 3Use a multimeter to check that the signal wire to the exhaust camshaft sensor on bank 1 is not shorted to ground (the body).
- 4Use a multimeter to check that the supply wire to the exhaust camshaft sensor on bank 1 is not broken.
- 5Check that the connector at the exhaust camshaft sensor is secure, since loose connections can cause this fault.
- 6If the fault returns, have a workshop check the exhaust camshaft sensor and its wiring.
Symptome, die Sie bemerken können1
- Engine is hard to start
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.