Was bedeutet der Fehlercode ECM-P060A02?

Diagnose und Fehlercodedefinition für ECM-P060A02 (Volvo C30 (2007–2013), Volvo C70 (2006–2013), Volvo C70 (2006–2013)). Steuergerätereparatur bei OBD Tuning.

VOLVO

ECM-P060A02 - Internal Control Module Monitoring Processor Performance. General Failure Information. General signal failure

System

Motorsteuergerät (ECM)

Volvo-Modelle, für die dieser Fehlercode gilt

Gilt für folgende Modelle:

12 Modelle

C30 (2007–2013), C70 (2006–2013), S40 (2004–2013), S60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V50 (2004–2013), V60 (2011–), V70 (2008–), XC60 (2009–), XC70 (2008–)

Modelle nach Baujahr und Motor anzeigen (40)

Was bedeutet der Fehlercode?

The ECM monitors the fuel system and its components. The code is set when the signal from the injectors is wrong with the engine running. It is a general signal fault code and does not state a more specific fault type.

Mögliche Ursachen

Damaged injectors, or injectors of the wrong type

Was Sie tun können

1Read the code with the ignition on and note whether it is active right now
2Check that the battery is charged and that the battery terminals and earth connections are tight and clean
3Disconnect the connector at the ECM and use a multimeter to check that the injector wiring has no short to earth or to other wires
4If you have a diagnostic tool: activate the injectors one at a time and listen for each one working
5If the fault comes back, have a workshop replace any damaged injectors or injectors of the wrong type

Symptome, die Sie bemerken können5

Warning symbol and message in the display
The car feels weak and lacks power, especially when pulling away from a standstill
The engine hesitates, surges or runs roughly during acceleration or deceleration
The engine hesitates, surges or runs roughly at constant speed
The problems may be present all the time or only now and then

Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.