Zum Inhalt springen
    OBD Tuning
    SENDEN SIE AN UNS
    SENDEN SIE AN UNS
    Startseite
    Fehlercodes
    VOLVO
    ECM-P064611
    VOLVO

    ECM-P064611 - A/C Clutch Relay Control Circuit Low. General Electrical Failures. Circuit short to ground

    System

    Motorsteuergerät (ECM)

    Volvo-Modelle, für die dieser Fehlercode gilt

    Gilt für folgende Modelle:

    9 Modelle

    S60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V70 (2008–), XC60 (2009–), XC70 (2008–), XC90 (2003–)

    Modelle nach Baujahr und Motor anzeigen (32)
    • Volvo S60 (2011–)2011Alle Motoren außer: B6304T4, D4162T, D5204T2, D5244T10
    • Volvo S60 (2011–)2012Nur Motor: B4164T, B4164T2, B4164T3, B4204T7, B5254T5
    • Volvo S60 (2011–)2013–2014Nur Motor: B4164T, B4164T2, B4164T3, B4204T7
    • Volvo S60 (2011–)2015Nur Motor: B4164T, B4164T2, B4164T3
    • Volvo S80 (2007–)2007Alle Motoren außer: B6324S, B8444S
    • Volvo S80 (2007–)2008Nur Motor: B5254T6, D5244T4, D5244T5
    • Volvo S80 (2007–)2009Nur Motor: B5254T6, B5254T8, D5244T4, D5244T5
    • Volvo S80 (2007–)2010Nur Motor: B4204T6, B5254T10, B5254T11, B5254T8, D4164T
    • Volvo S80 (2007–)2011Nur Motor: B4164T, B4204T6, B4204T7, B5254T10, B5254T11, B5254T8, D4164T
    • Volvo S80 (2007–)2012Nur Motor: B4164T, B4164T2, B4204T6, B4204T7, B5254T10
    • Volvo S80 (2007–)2013–2014Nur Motor: B4164T, B4164T2, B4204T6, B4204T7
    • Volvo S80 (2007–)2015Nur Motor: B4164T
    • Volvo V40 (2013–)2013Nur Motor: B4164T, B4164T3
    • Volvo V40 (2013–)2014–2015Nur Motor: B4164T, B4164T3, B4164T4
    • Volvo V40 Cross Country (2013–)2013–2015Nur Motor: B4164T
    • Volvo V60 (2011–)2011Nur Motor: B4164T, B4164T3, B4204T6, B4204T7
    • Volvo V60 (2011–)2012–2014Nur Motor: B4164T, B4164T2, B4164T3, B4204T7
    • Volvo V60 (2011–)2015Nur Motor: B4164T, B4164T2, B4164T3
    • Volvo V70 (2008–)2008Nur Motor: B5254T6, D5244T4, D5244T5
    • Volvo V70 (2008–)2009Nur Motor: B5254T6, B5254T8, D5244T4, D5244T5
    • Volvo V70 (2008–)2010Nur Motor: B4204T6, B5254T10, B5254T11, D4164T
    • Volvo V70 (2008–)2011Nur Motor: B4164T, B4204T6, B4204T7, B5254T10, B5254T11, D4164T
    • Volvo V70 (2008–)2012Nur Motor: B4164T, B4164T2, B4204T7, B5254T10
    • Volvo V70 (2008–)2013–2014Nur Motor: B4164T, B4164T2, B4204T7
    • Volvo V70 (2008–)2015Nur Motor: B4164T, B4164T2
    • Volvo XC60 (2009–)2009Alle Motoren außer: B6304T2
    • Volvo XC60 (2009–)2010Nur Motor: B4204T6
    • Volvo XC60 (2009–)2011–2012Nur Motor: B4204T6, B4204T7
    • Volvo XC60 (2009–)2013–2015Nur Motor: B4204T7
    • Volvo XC70 (2008–)2008Alle Motoren außer: B6324S
    • Volvo XC70 (2008–)2009Nur Motor: D5244T4, D5244T5
    • Volvo XC90 (2003–)2013–2014Nur Motor: D5244T18, D5244T5

    Was bedeutet der Fehlercode?

    The fault concerns a signal to the A/C coupling relay that is too low, which may be caused by a short to ground. The engine control module (ECM) drives the A/C compressor's stroke volume through a control valve and compares the valve signal with expected values. At high torque output the module can switch the A/C function off.

    Mögliche Ursachen

    • Signal wire shorted to ground
    • Signal wire shorted to supply voltage, or a faulty A/C relay; see fault code ECM-P064712
    • Poor contact or oxidation at the connectors, or an open signal wire; see fault code ECM-P064513
    • Poor contact or oxidation at the terminals, an open supply wire, or a faulty control valve; see fault code ECM-P064519
    • Open circuit or short to ground in the signal wire or the supply wire

    Was Sie tun können

    1. 1Check that the fuses are intact and that the connectors are secure and free from corrosion
    2. 2With the ignition off, use a multimeter to check that the signal cable to the control valve is not shorted to ground and has no open circuit
    3. 3If you have diagnostic equipment, activate the control valve with the tool and check that the A/C compressor responds
    4. 4If the wiring is intact but the fault remains, have a workshop check the A/C system relays and the control valve

    Symptome, die Sie bemerken können4

    • The A/C system does not operate
    • Cooling from the A/C is too weak or slow in the rear or front section
    • Uneven temperature in the cabin
    • The heater does not work or does not get warm enough

    Was der Fehler beeinflussen kann1

    • The A/C system is switched off

    Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.

    OBD Tuning

    Schwedens führendes Kompetenzzentrum für Automotorelektronik. Wir bieten professionelle ECU-Optimierung, Steuergerätereparatur und Diagnose mit 12-monatiger Garantie.

    Dienstleistungen

    • Motoroptimierung
    • ECU-Reparatur
    • Modul-Klonen
    • Kombiinstrument
    • SRS / Airbag
    • Wegfahrsperre

    Datenbank & Diagnose

    • ECU-Datenbank
    • DTC Fehlercodekatalog
    • Diagnoseanleitungen & Messwerte
    • KI-Fehlercode-Analysator
    • Neuigkeiten

    ECU-Hersteller

    • Bosch
    • Continental
    • Delphi
    • Delco
    • Denso
    • Magneti Marelli
    • Siemens / VDO
    • Keihin
    • Temic

    Unternehmen

    • Über uns
    • Kontakt
    • Workshop-Partner
    • Versandanleitung
    • Garantie
    • Häufig gestellte Fragen
    • AGB
    • Datenschutz
    • Sitemap

    • Motoroptimierung
    • ECU-Reparatur
    • Modul-Klonen
    • Kombiinstrument
    • SRS / Airbag
    • Wegfahrsperre

    • ECU-Datenbank
    • DTC Fehlercodekatalog
    • Diagnoseanleitungen & Messwerte
    • KI-Fehlercode-Analysator
    • Neuigkeiten

    • Bosch
    • Continental
    • Delphi
    • Delco
    • Denso
    • Magneti Marelli
    • Siemens / VDO
    • Keihin
    • Temic

    • Über uns
    • Kontakt
    • Workshop-Partner
    • Versandanleitung
    • Garantie
    • Häufig gestellte Fragen
    • AGB
    • Datenschutz
    • Sitemap

    Besuchen Sie uns

    Gjuterigatan 29, Karlstad

    Rufen Sie uns an

    054-830 480

    Schreiben Sie uns eine E-Mail

    service@obdtuning.se

    © 2026 OBD Tuning Karlstad. Alle Rechte vorbehalten.