Was bedeutet der Fehlercode ECM-P085200?

Diagnose und Fehlercodedefinition für ECM-P085200 (Volvo S60 (2011–), Volvo S80 (2007–), Volvo V40 (2013–)). Steuergerätereparatur bei OBD Tuning.

VOLVO

ECM-P085200 - Park / Neutral Switch Input Circuit High. General Failure Information. No sub type information

System

Motorsteuergerät (ECM)

Volvo-Modelle, für die dieser Fehlercode gilt

Gilt für folgende Modelle:

8 Modelle

S60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V70 (2008–), XC60 (2009–), XC70 (2008–)

Modelle nach Baujahr und Motor anzeigen (8)

Was bedeutet der Fehlercode?

The code means that the CAN signal from the TCM says starting is allowed, while the signal on the wire from the gear selector says the opposite. The engine control module monitors this to decide whether engine start is allowed, and the fault is checked with the ignition on.

Mögliche Ursachen

The root cause is in the transmission control module (TCM)

Was Sie tun können

1Look for the root cause in the transmission control module (TCM): read off and remedy its fault codes there first
2Check that the fuses are intact. The locations are shown in the instruction manual or on the fuse list
3If you have a diagnostic tool, check in live data that the selector position agrees with the CAN signal as you move the selector between P/N and other positions
4If the fault remains, have a workshop investigate the TCM, where the cause is given as lying

Symptome, die Sie bemerken können2

The starter drags the engine round slowly and it starts with difficulty
The engine does not start, at some times or all the time

Was der Fehler beeinflussen kann1

The ECM uses the signal received over CAN instead

Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.