Zum Inhalt springen
    OBD Tuning
    SENDEN SIE AN UNS
    SENDEN SIE AN UNS
    Startseite
    Fehlercodes
    VOLVO
    ECM-P08B000
    VOLVO

    ECM-P08B000 - Neutral Position Sensor "B" Circuit High. General Failure Information. No sub type information

    System

    Motorsteuergerät (ECM)

    Volvo-Modelle, für die dieser Fehlercode gilt

    Gilt für folgende Modelle:

    8 Modelle

    S60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V70 (2008–), XC60 (2009–), XC70 (2008–)

    Modelle nach Baujahr und Motor anzeigen (28)
    • Volvo S60 (2011–)2011Nur Motor: B4164T, B4164T3
    • Volvo S60 (2011–)2012Alle Motoren außer: B4204T7, B5254T5, B6304T4, D4162T
    • Volvo S60 (2011–)2013Nur Motor: B4164T, B4164T2, B4164T3, D5204T3, D5204T7, D5244T11, D5244T15
    • Volvo S60 (2011–)2014Alle Motoren außer: B4204T7, B5204T8, B5204T9, B5254T12, B5254T14, B6304T4, D4162T
    • Volvo S60 (2011–)2015Alle Motoren außer: B5204T8, B5204T9, B5254T12, B5254T14, B6304T3, B6304T4, B6304T5, D4162T
    • Volvo S80 (2007–)2011Nur Motor: B4164T
    • Volvo S80 (2007–)2012Nur Motor: B4164T, B4164T2, D5204T3, D5244T11, D5244T15
    • Volvo S80 (2007–)2013Nur Motor: B4164T, B4164T2, D5204T3, D5204T7, D5244T11, D5244T15
    • Volvo S80 (2007–)2014Alle Motoren außer: B4204T6, B4204T7, B5254T12, B5254T14, B6304T4, B6324S4, B6324S5, D4162T
    • Volvo S80 (2007–)2015Alle Motoren außer: B6304T4, B6324S4, B6324S5, D4162T
    • Volvo V40 (2013–)2013Nur Motor: B4164T, B4164T3, D5204T4, D5204T6
    • Volvo V40 (2013–)2014Nur Motor: B4164T, B4164T3, B4164T4, D5204T4, D5204T6
    • Volvo V40 (2013–)2015Alle Motoren außer: B5204T8, B5204T9, D4162T
    • Volvo V40 Cross Country (2013–)2013–2014Nur Motor: B4164T, D5204T4, D5204T6
    • Volvo V40 Cross Country (2013–)2015Nur Motor: B4164T, B4204T11, D4204T14, D5204T6
    • Volvo V60 (2011–)2011Nur Motor: B4164T, B4164T3
    • Volvo V60 (2011–)2012Alle Motoren außer: B4204T7, B6304T4, D4162T
    • Volvo V60 (2011–)2013Alle Motoren außer: B4204T7, B5204T8, B5204T9, B6304T4, D4162T, D82PHEV
    • Volvo V60 (2011–)2014Alle Motoren außer: B4204T7, B5204T8, B5204T9, B5254T12, B6304T4, D4162T, D82PHEV
    • Volvo V60 (2011–)2015Alle Motoren außer: B5204T9, B5254T12, B6304T3, B6304T4, B6304T5, D4162T, D82PHEV, D87PHEV
    • Volvo V70 (2008–)2011Nur Motor: B4164T
    • Volvo V70 (2008–)2012Nur Motor: B4164T, B4164T2, D5204T3, D5244T11, D5244T15
    • Volvo V70 (2008–)2013–2014Alle Motoren außer: B4204T7, B5204T9, B6304T4, B6324S5, D4162T
    • Volvo V70 (2008–)2015Alle Motoren außer: B5204T9, B6304T4, D4162T
    • Volvo XC60 (2009–)2012Nur Motor: D5204T3, D5244T11, D5244T15, D5244T17
    • Volvo XC60 (2009–)2013–2014Alle Motoren außer: B4204T7, B6304T4, B6324S4, B6324S5
    • Volvo XC60 (2009–)2015Alle Motoren außer: B4204T7, B5204T9, B5254T12, B5254T14, B6304T4, B6324S4, B6324S5
    • Volvo XC70 (2008–)2012–2015Alle Motoren außer: B6304T4, B6324S4, B6324S5

    Was bedeutet der Fehlercode?

    The signal from the redundancy sensor in neutral position sensor B is too high. This points to a signal fault with a short to voltage. The fault is checked with the ignition on and then with the engine running.

    Mögliche Ursachen

    • Signal wire shorted to voltage
    • Short to voltage in the connector
    • Damaged neutral position sensor

    Was Sie tun können

    1. 1Check that the fuses are intact. The locations are shown in the instruction manual or on the fuse list
    2. 2Use a multimeter to check that the signal wire to sensor B has no contact with the battery positive and has no break
    3. 3Check that the connector at the sensor is firmly seated and free from oxidation
    4. 4Try automatic stop-start with the buttons and controls to see whether the function is affected
    5. 5If the fault remains after these checks, have a workshop investigate neutral position sensor B

    Symptome, die Sie bemerken können3

    • Automatic engine stop-start does not work while driving
    • Automatic engine stop-start does not work at idle
    • Starting and auto-start do not work

    Was der Fehler beeinflussen kann1

    • The automatic engine stop-start function is switched off

    Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.

    OBD Tuning

    Schwedens führendes Kompetenzzentrum für Automotorelektronik. Wir bieten professionelle ECU-Optimierung, Steuergerätereparatur und Diagnose mit 12-monatiger Garantie.

    Dienstleistungen

    • Motoroptimierung
    • ECU-Reparatur
    • Modul-Klonen
    • Kombiinstrument
    • SRS / Airbag
    • Wegfahrsperre

    Datenbank & Diagnose

    • ECU-Datenbank
    • DTC Fehlercodekatalog
    • Diagnoseanleitungen & Messwerte
    • KI-Fehlercode-Analysator
    • Neuigkeiten

    ECU-Hersteller

    • Bosch
    • Continental
    • Delphi
    • Delco
    • Denso
    • Magneti Marelli
    • Siemens / VDO
    • Keihin
    • Temic

    Unternehmen

    • Über uns
    • Kontakt
    • Workshop-Partner
    • Versandanleitung
    • Garantie
    • Häufig gestellte Fragen
    • AGB
    • Datenschutz
    • Sitemap

    • Motoroptimierung
    • ECU-Reparatur
    • Modul-Klonen
    • Kombiinstrument
    • SRS / Airbag
    • Wegfahrsperre

    • ECU-Datenbank
    • DTC Fehlercodekatalog
    • Diagnoseanleitungen & Messwerte
    • KI-Fehlercode-Analysator
    • Neuigkeiten

    • Bosch
    • Continental
    • Delphi
    • Delco
    • Denso
    • Magneti Marelli
    • Siemens / VDO
    • Keihin
    • Temic

    • Über uns
    • Kontakt
    • Workshop-Partner
    • Versandanleitung
    • Garantie
    • Häufig gestellte Fragen
    • AGB
    • Datenschutz
    • Sitemap

    Besuchen Sie uns

    Gjuterigatan 29, Karlstad

    Rufen Sie uns an

    054-830 480

    Schreiben Sie uns eine E-Mail

    service@obdtuning.se

    © 2026 OBD Tuning Karlstad. Alle Rechte vorbehalten.