VOLVO
ECM-P133000 - Injector Control Pressure Lower Than Desired (engine running). General Failure Information. No sub type information
System
Motorsteuergerät (ECM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
8 ModelleS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Modelle nach Baujahr und Motor anzeigen (8)
- Volvo S60 (2011–)2014–2015Nur Motor: D4204T5
- Volvo S80 (2007–)2014–2015Nur Motor: D4204T5
- Volvo V40 (2013–)2015Nur Motor: D4204T14
- Volvo V40 Cross Country (2013–)2015Nur Motor: D4204T14
- Volvo V60 (2011–)2014–2015Nur Motor: D4204T5
- Volvo V70 (2008–)2014–2015Nur Motor: D4204T5
- Volvo XC60 (2009–)2014–2015Nur Motor: D4204T5
- Volvo XC70 (2008–)2014–2015Nur Motor: D4204T5
Was bedeutet der Fehlercode?
The engine control module (ECM) compares the fuel pressure on the high-pressure side with the largest permitted deviation below the correct pressure. The pressure depends on engine load and speed, and the check is only made with the engine running. The code is set when the pressure is too low. The cause can be fuel starvation on the low-pressure side, a leak, a blocked fuel filter, air, or damaged control valves.
Mögliche Ursachen
- Waxing of diesel at low fuel temperatures
- Internal or external fuel leak on the high-pressure side
- Poor fuel supply on the low-pressure side
- Blocked fuel filter
- Damaged fuel flow control valve or fuel pressure control valve
- Air in the fuel system
Was Sie tun können
- 1Check the fuel level in the tank and top up if it is low.
- 2If there are fault codes for the fuel pump, deal with them first.
- 3Look for leaks in the fuel system. A blocked fuel filter can cause the same fault, so have a workshop check it.
- 4If you have a diagnostic tool, compare the measured fuel pressure with the requested one in live data at idle.
- 5Have a workshop check the control valves, the tightness of the injector valves and the connectors and wiring of the fuel pressure sensor, as this needs measurements.
Symptome, die Sie bemerken können4
- The engine does not start, but the starter motor turns
- Poor performance, the car lacks power, especially when pulling away from a standstill
- Uneven idle
- The engine stalls, both at idle and while driving
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.