VOLVO
ECM-P155400 - Cylinder 4 Injector Circuit Range/Performance. General Failure Information. No sub type information
System
Motorsteuergerät (ECM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
5 ModelleS80 (2007–), V70 (2008–), XC60 (2009–), XC70 (2008–), XC90 (2003–)
Modelle nach Baujahr und Motor anzeigen (9)
- Volvo S80 (2007–)2007Nur Motor: D5244T4, D5244T5
- Volvo S80 (2007–)2008–2009Nur Motor: D4204T, D5244T4, D5244T5
- Volvo S80 (2007–)2010Nur Motor: D4204T
- Volvo V70 (2008–)2008–2009Nur Motor: D4204T, D5244T4, D5244T5
- Volvo V70 (2008–)2010Nur Motor: D4204T
- Volvo XC60 (2009–)2009Alle Motoren außer: B6304T2
- Volvo XC70 (2008–)2008Alle Motoren außer: B6324S
- Volvo XC70 (2008–)2009Nur Motor: D5244T4, D5244T5
- Volvo XC90 (2003–)2013–2014Nur Motor: D5244T18, D5244T5
Was bedeutet der Fehlercode?
The code concerns the signal to the injection valve for cylinder 4. The engine control module (ECM) monitors the valve's output stage and how much fuel it injects, and sets the code when something does not match, for example if the quantity becomes too large.
Mögliche Ursachen
- Contact resistance or corrosion in the connectors and connections
- Loose connector
- Open circuit in the signal wire, or in the positive or negative wire
- With fault code ECM-P120412: the signal wire is shorted to voltage, or the injection valve is damaged
- With fault code ECM-P120411: a short between the signal wires, or the signal wire is shorted to ground
Was Sie tun können
- 1Cylinder 4 is the fourth cylinder counted from the right-hand side of the vehicle, with cylinder 1 furthest from the flywheel.
- 2Check that the fuses are intact. Their location is in the owner's manual or on the fuse box cover.
- 3Check the connector to the cylinder 4 injection valve for looseness, contact resistance and corrosion.
- 4With the ignition off, use a multimeter to check that the wires to the cylinder 4 injection valve have no break and no contact with ground or voltage.
- 5If you have a diagnostic tool, activate the cylinder 4 injection valve and listen for it working.
- 6If the fault remains, have a workshop check the cylinder 4 injection valve and its control.
Symptome, die Sie bemerken können4
- The engine may be hard to start, or not start at all, and this may be noticeable all the time or only now and then
- Yellow warning symbol and text message in the display
- The check engine lamp lights or behaves abnormally
- The engine lacks power or performs poorly
Was der Fehler beeinflussen kann3
- Injection from cylinder 4 stops
- The engine speed is limited
- The car may go into limp home mode
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.