VOLVO
ECM-P162100 - Immobolizer Key Not Programmed - ECM/PCM. General Failure Information. No sub type information
System
Motorsteuergerät (ECM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
3 ModelleS60 (2011–), S80 (2007–), V70 (2008–)
Modelle nach Baujahr und Motor anzeigen (9)
- Volvo S60 (2011–)2011–2012Nur Motor: B5254T5
- Volvo S80 (2007–)2007–2008Nur Motor: B5254T6
- Volvo S80 (2007–)2009Nur Motor: B5254T6, B5254T8
- Volvo S80 (2007–)2010–2011Nur Motor: B5254T10, B5254T11, B5254T8
- Volvo S80 (2007–)2012Nur Motor: B5254T10
- Volvo V70 (2008–)2008Nur Motor: B5254T6
- Volvo V70 (2008–)2009Nur Motor: B5254T6, B5254T8
- Volvo V70 (2008–)2010–2011Nur Motor: B5254T10, B5254T11
- Volvo V70 (2008–)2012Nur Motor: B5254T10
Was bedeutet der Fehlercode?
The engine control module (ECM) lacks the immobilizer code that must match the central electronic module (CEM), so the immobilizer cannot be checked. The engine does not start even though the starter motor turns. The fault code is also set in the event of an internal fault in the engine control module.
Mögliche Ursachen
- The ECM has not been programmed and holds no immobilizer code
- Damaged engine control module (ECM)
Was Sie tun können
- 1Read off the fault codes and note which are present
- 2If the engine control module is not programmed: have a workshop program it
- 3If the engine control module is damaged: have a workshop replace it
- 4After a repair or programming: switch the ignition on, reconnect any disconnected connectors, start the engine and read off the fault codes again
Symptome, die Sie bemerken können1
- The starter turns over, yet the engine fails to start
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.