VOLVO
ECM-P162300 - Software Incompatibility with Vehicle Immobilizer Control Module. General Failure Information. No sub type information
System
Motorsteuergerät (ECM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
3 ModelleS60 (2011–), S80 (2007–), V70 (2008–)
Modelle nach Baujahr und Motor anzeigen (9)
- Volvo S60 (2011–)2011–2012Nur Motor: B5254T5
- Volvo S80 (2007–)2007–2008Nur Motor: B5254T6
- Volvo S80 (2007–)2009Nur Motor: B5254T6, B5254T8
- Volvo S80 (2007–)2010–2011Nur Motor: B5254T10, B5254T11, B5254T8
- Volvo S80 (2007–)2012Nur Motor: B5254T10
- Volvo V70 (2008–)2008Nur Motor: B5254T6
- Volvo V70 (2008–)2009Nur Motor: B5254T6, B5254T8
- Volvo V70 (2008–)2010–2011Nur Motor: B5254T10, B5254T11
- Volvo V70 (2008–)2012Nur Motor: B5254T10
Was bedeutet der Fehlercode?
The engine control module (ECM) has either not been programmed or has an internal fault, and then it cannot match the immobilizer code with the central electronic module (CEM). The engine does not start even though the starter motor turns. Although the code describes incompatible software, the condition concerns the immobilizer code itself.
Mögliche Ursachen
- Damaged engine control module (ECM)
Was Sie tun können
- 1Read off the fault codes and note which are present
- 2If the fault code returns: have a workshop replace the engine control module (ECM)
- 3After a repair: switch the ignition on, reconnect any disconnected connectors, start the engine and read off the fault codes again
Symptome, die Sie bemerken können1
- The starter turns over, yet the engine fails to start
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.