VOLVO
ECM-P167508 - Injector data not programmed. General Failure Information. Bus Signal / Message Failures
System
Motorsteuergerät (ECM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
8 ModelleS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Modelle nach Baujahr und Motor anzeigen (8)
- Volvo S60 (2011–)2014–2015Nur Motor: D4204T5
- Volvo S80 (2007–)2014–2015Nur Motor: D4204T5
- Volvo V40 (2013–)2015Nur Motor: D4204T14
- Volvo V40 Cross Country (2013–)2015Nur Motor: D4204T14
- Volvo V60 (2011–)2014–2015Nur Motor: D4204T5
- Volvo V70 (2008–)2014–2015Nur Motor: D4204T5
- Volvo XC60 (2009–)2014–2015Nur Motor: D4204T5
- Volvo XC70 (2008–)2014–2015Nur Motor: D4204T5
Was bedeutet der Fehlercode?
The engine control module (ECM) receives the injector data over the LIN bus. The fault code is set when messages from an injector are missing, meaning the communication between the control module and the injector is absent. The most recently used injector data is used instead.
Mögliche Ursachen
- LIN communication between the injector and the control module is not working
- Internal fault in the injector
Was Sie tun können
- 1Read off the fault codes and note which are present
- 2Check that the connectors to the injectors are firmly seated and free from oxide
- 3Clear the fault code and take the car for a short drive. Read off the fault codes again afterwards
- 4If the fault code returns: have a workshop check the injector
Symptome, die Sie bemerken können1
- No noticeable symptoms for the driver
Was der Fehler beeinflussen kann1
- The control module uses the most recently used value from the injector
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.