VOLVO
ECM-P200817 - Intake Manifold Runner Control Circuit / Open (Bank 1). General Electrical Failures. Circuit voltage above threshold
System
Motorsteuergerät (ECM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
5 ModelleS80 (2007–), V70 (2008–), XC60 (2009–), XC70 (2008–), XC90 (2003–)
Modelle nach Baujahr und Motor anzeigen (6)
- Volvo S80 (2007–)2007–2009Nur Motor: D5244T4, D5244T5
- Volvo V70 (2008–)2008–2009Nur Motor: D5244T4, D5244T5
- Volvo XC60 (2009–)2009Alle Motoren außer: B6304T2
- Volvo XC70 (2008–)2008Alle Motoren außer: B6324S
- Volvo XC70 (2008–)2009Nur Motor: D5244T4, D5244T5
- Volvo XC90 (2003–)2013–2014Nur Motor: D5244T18, D5244T5
Was bedeutet der Fehlercode?
The engine control module (ECM) monitors the swirl throttle motor circuit and sets the code when the signal is wrong. The code concerns a circuit voltage that is too high. This may be caused by a signal cable short-circuited to supply voltage, but also by an open circuit or a sticking swirl damper motor.
Mögliche Ursachen
- Signal cable short-circuited to supply voltage
- Open circuit in the signal cable
- Damaged swirl throttle motor
- Signal cable short-circuited to ground
- Swirl damper motor or linkage sticking
- Damaged linkage between the swirl throttle motor and the swirl throttle duct
Was Sie tun können
- 1Check that the fuses are intact
- 2If you have a diagnostic tool: start the engine and read off the status of the code
- 3Check that the signal cable to the swirl throttle motor is not pinched or chafed
- 4Use a multimeter to check that the cable has no short circuit to supply voltage or ground
- 5If the fault remains, have a workshop check the swirl throttle motor and its connectors
Symptome, die Sie bemerken können1
- No noticeable symptoms for the driver
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.