VOLVO
ECM-P201600 - Intake Manifold Runner Position Sensor/Switch Circuit Low (Bank 1). General Failure Information. No sub type information
System
Motorsteuergerät (ECM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
5 ModelleS80 (2007–), V70 (2008–), XC60 (2009–), XC70 (2008–), XC90 (2003–)
Modelle nach Baujahr und Motor anzeigen (6)
- Volvo S80 (2007–)2007–2009Nur Motor: D5244T4, D5244T5
- Volvo V70 (2008–)2008–2009Nur Motor: D5244T4, D5244T5
- Volvo XC60 (2009–)2009Alle Motoren außer: B6304T2
- Volvo XC70 (2008–)2008Alle Motoren außer: B6324S
- Volvo XC70 (2008–)2009Nur Motor: D5244T4, D5244T5
- Volvo XC90 (2003–)2013–2014Nur Motor: D5244T18, D5244T5
Was bedeutet der Fehlercode?
The engine control module (ECM) checks the supply voltage to the swirl damper motor position sensor. The code is set when the signal is incorrect and is tested with the ignition on. The cause may be a short circuit in the supply or signal wire, or a damaged sensor.
Mögliche Ursachen
- Power supply short-circuited to battery voltage
- Signal wire short-circuited to voltage
- Open circuit in the earth lead
- Damaged sensor
- Power supply short-circuited to ground
- Short circuit to ground in the signal wire
Was Sie tun können
- 1Check that the fuses are intact
- 2Check that the connector to the swirl damper position sensor is clean and secure
- 3Use a multimeter to check that the supply wire has no contact with ground and that the earth lead has no open circuit
- 4If you have a diagnostic tool: read the status of the code with the ignition on and see whether it is active
- 5If the fault remains, have a workshop check the position sensor and the wiring with diagnostic equipment
Symptome, die Sie bemerken können1
- No noticeable symptoms for the driver
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.