VOLVO
ECM-P212100 - Throttle/Pedal Position Sensor/Switch D Circuit Range/Performance. General Failure Information. No sub type information
System
Motorsteuergerät (ECM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
9 ModelleC30 (2007–2013), S40 (2004–2013), S60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V50 (2004–2013), V60 (2011–), V70 (2008–)
Modelle nach Baujahr und Motor anzeigen (13)
- Volvo C30 (2007–2013)2011–2013Nur Motor: D4162T
- Volvo S40 (2004–2013)2011–2012Nur Motor: D4162T
- Volvo S60 (2011–)2011–2015Nur Motor: D4162T
- Volvo S80 (2007–)2008–2010Nur Motor: B4204S3, B4204S4, D4204T
- Volvo S80 (2007–)2011Nur Motor: B4204S3, B4204S4
- Volvo S80 (2007–)2012–2015Nur Motor: D4162T
- Volvo V40 (2013–)2013–2015Nur Motor: D4162T
- Volvo V40 Cross Country (2013–)2013–2015Nur Motor: D4162T
- Volvo V50 (2004–2013)2011–2012Nur Motor: D4162T
- Volvo V60 (2011–)2011–2015Nur Motor: D4162T
- Volvo V70 (2008–)2008–2010Nur Motor: B4204S3, B4204S4, D4204T
- Volvo V70 (2008–)2011Nur Motor: B4204S3, B4204S4
- Volvo V70 (2008–)2012–2015Nur Motor: D4162T
Was bedeutet der Fehlercode?
The control module compares the readings from two accelerator pedal sensors. The code is set when the signal from the accelerator pedal sensor is missing, incorrect or too low. It can also be set wrongly after a module in the car has been reprogrammed.
Mögliche Ursachen
- Communication fault on the CAN bus
- Damaged accelerator pedal position sensor
- Poor contact, oxidation or a loose plug in the connector
- The signal wire is short-circuited to ground
Was Sie tun können
- 1Start by checking the central electronic module (CEM) and the other control modules involved for stored codes, and fix those first
- 2Clear this code only after the codes in the other control modules have been fixed and cleared
- 3If a control module in the vehicle has recently been reprogrammed, the code may have been set incorrectly. In that case you can disregard it
- 4Check that the fuses are intact
- 5Check the connectors at the pedal sensor and the engine control module for contact resistance, looseness and oxidation
- 6If the fault remains, have a workshop with diagnostic equipment trace the CAN communication and the pedal sensor
Symptome, die Sie bemerken können3
- Poor response from the accelerator pedal
- A text message and a warning symbol appear in the display
- The engine lacks power and performs poorly
Was der Fehler beeinflussen kann1
- Engine torque may be limited
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.