VOLVO
ECM-P212600 - Throttle/Pedal Position Sensor/Switch E Circuit Range/Performance. General Failure Information. No sub type information
System
Motorsteuergerät (ECM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
2 ModelleS80 (2007–), V70 (2008–)
Modelle nach Baujahr und Motor anzeigen (2)
Was bedeutet der Fehlercode?
The engine control module (ECM) has detected that the pulse length of the pulse width modulated (PWM) signal from accelerator pedal sensor circuit 2 is wrong. The fault therefore concerns the accelerator pedal signal. The code can also have been set in error after a control module in the car was reprogrammed, so check whether any module has recently been reprogrammed.
Mögliche Ursachen
- Damaged accelerator pedal sensor
- Code set in error after a control module in the car was reprogrammed
Was Sie tun können
- 1Check whether any control module in the car has recently been reprogrammed, as that can cause this code to be set in error
- 2Check that the accelerator pedal connector and wiring are secure and not chafed or corroded
- 3With a diagnostic tool, check that the pedal value in live data follows slow presses and releases of the pedal
- 4Remedy as needed, then erase the code and road test the car to check that it does not come back
- 5Replace the accelerator pedal sensor only if the fault remains and the wiring is intact
Symptome, die Sie bemerken können1
- Poor response from the accelerator pedal
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.