VOLVO
ECM-P223800 - O2 Sensor Positive Current Control Circuit Low - Bank 1, Sensor 1. General Failure Information. No sub type information
System
Motorsteuergerät (ECM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
12 ModelleC30 (2007–2013), S40 (2004–2013), S60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V50 (2004–2013), V60 (2011–), V70 (2008–), XC60 (2009–), XC70 (2008–), XC90 (2003–)
Modelle nach Baujahr und Motor anzeigen (22)
- Volvo C30 (2007–2013)2011–2013Nur Motor: D4162T
- Volvo S40 (2004–2013)2011–2012Nur Motor: D4162T
- Volvo S60 (2011–)2011Nur Motor: B4164T, B4164T3, B5254T5, D4162T
- Volvo S60 (2011–)2012Nur Motor: B4164T, B4164T2, B4164T3, B5254T5, D4162T
- Volvo S60 (2011–)2013–2015Nur Motor: B4164T, B4164T2, B4164T3, D4162T
- Volvo S80 (2007–)2007–2009Nur Motor: D5244T4, D5244T5
- Volvo S80 (2007–)2011Nur Motor: B4164T
- Volvo S80 (2007–)2012–2014Nur Motor: B4164T, B4164T2, D4162T
- Volvo S80 (2007–)2015Nur Motor: B4164T, D4162T
- Volvo V40 (2013–)2013Nur Motor: B4164T, B4164T3, D4162T
- Volvo V40 (2013–)2014–2015Nur Motor: B4164T, B4164T3, B4164T4, D4162T
- Volvo V40 Cross Country (2013–)2013–2015Nur Motor: B4164T, D4162T
- Volvo V50 (2004–2013)2011–2012Nur Motor: D4162T
- Volvo V60 (2011–)2011Nur Motor: B4164T, B4164T3, D4162T
- Volvo V60 (2011–)2012–2015Nur Motor: B4164T, B4164T2, B4164T3, D4162T
- Volvo V70 (2008–)2008–2009Nur Motor: D5244T4, D5244T5
- Volvo V70 (2008–)2011Nur Motor: B4164T
- Volvo V70 (2008–)2012–2015Nur Motor: B4164T, B4164T2, D4162T
- Volvo XC60 (2009–)2009Alle Motoren außer: B6304T2
- Volvo XC70 (2008–)2008Alle Motoren außer: B6324S
- Volvo XC70 (2008–)2009Nur Motor: D5244T4, D5244T5
- Volvo XC90 (2003–)2013–2014Nur Motor: D5244T18, D5244T5
Was bedeutet der Fehlercode?
The module reads the front heated oxygen sensor, which reports on the fuel and air mixture. The code is set when the signal from the sensor is faulty, here too low. The fault can also lie in the pump current wire if the pump current has stopped.
Mögliche Ursachen
- Short to earth on the signal wire
- Open circuit in the signal wire
- Contact resistance or oxidation in the connections
- Open circuit in the pump current wire
- Damaged front heated oxygen sensor (HO2S)
- Codes ECM-P223700 or ECM-P223900 stored at the same time
Was Sie tun können
- 1Check that the fuses are intact
- 2Check the oxygen sensor connections for contact resistance, looseness and oxidation. Do not use rust-dissolving spray or grease in the connector
- 3Use a multimeter to check that the signal wire has no short to earth
- 4If the wiring is in order, try a new oxygen sensor
- 5If the fault remains, have a workshop with diagnostic equipment diagnose further
Symptome, die Sie bemerken können1
- Malfunction indicator lamp (MIL) lit
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.