VOLVO
ECM-P231200 - Ignition Coil E Primary Control Circuit Low. General Failure Information. No sub type information
System
Motorsteuergerät (ECM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
3 ModelleS60 (2011–), S80 (2007–), V70 (2008–)
Modelle nach Baujahr und Motor anzeigen (9)
- Volvo S60 (2011–)2011–2012Nur Motor: B5254T5
- Volvo S80 (2007–)2007–2008Nur Motor: B5254T6
- Volvo S80 (2007–)2009Nur Motor: B5254T6, B5254T8
- Volvo S80 (2007–)2010–2011Nur Motor: B5254T10, B5254T11, B5254T8
- Volvo S80 (2007–)2012Nur Motor: B5254T10
- Volvo V70 (2008–)2008Nur Motor: B5254T6
- Volvo V70 (2008–)2009Nur Motor: B5254T6, B5254T8
- Volvo V70 (2008–)2010–2011Nur Motor: B5254T10, B5254T11
- Volvo V70 (2008–)2012Nur Motor: B5254T10
Was bedeutet der Fehlercode?
The signal to ignition coil 5 is too low according to the engine control module (ECM), which sets the code. This means the signal wire to ignition coil 5 has been short-circuited to ground. The code is general and applies only to ignition coil 5, not to the other ignition coils.
Mögliche Ursachen
- The signal wire to ignition coil 5 is short-circuited to ground
- The ignition coil is damaged
Was Sie tun können
- 1Check that the relevant fuses are intact; see the car's owner's manual for locations
- 2Read and note the code, clear it and test drive to see whether it returns
- 3Inspect the cable to ignition coil 5 for chafing and pinching, especially where it is secured by clips
- 4Use a multimeter to check that the signal wire to ignition coil 5 has no contact with ground (the body)
- 5Check the connector at ignition coil 5 for loose contacts and corrosion
- 6If the fault returns, have a workshop with diagnostic equipment check the ignition coil and the wiring
Symptome, die Sie bemerken können2
- The malfunction indicator lamp (MIL) lights up
- Not all cylinders are firing properly
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.