VOLVO
ECM-P250A16 - Engine Oil Level Sensor Circuit. General Electrical Failures. Circuit voltage below threshold
System
Motorsteuergerät (ECM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
5 ModelleS80 (2007–), V70 (2008–), XC60 (2009–), XC70 (2008–), XC90 (2003–)
Modelle nach Baujahr und Motor anzeigen (6)
- Volvo S80 (2007–)2007–2009Nur Motor: D5244T4, D5244T5
- Volvo V70 (2008–)2008–2009Nur Motor: D5244T4, D5244T5
- Volvo XC60 (2009–)2009Alle Motoren außer: B6304T2
- Volvo XC70 (2008–)2008Alle Motoren außer: B6324S
- Volvo XC70 (2008–)2009Nur Motor: D5244T4, D5244T5
- Volvo XC90 (2003–)2013–2014Nur Motor: D5244T18, D5244T5
Was bedeutet der Fehlercode?
The engine control module (ECM) keeps track of the engine oil level and calculates an average value from it. The code is stored when that calculated average is incorrect. Possible causes are an oil level that is too low, poor contact or a damaged oil level sensor.
Mögliche Ursachen
- Oil level too low
- Contact resistance or oxidation in the terminals (see also ECM-P250A1C)
- Damaged oil level sensor
Was Sie tun können
- 1Check the oil level with the dipstick and top up with the correct oil if it is low
- 2Check that the relevant fuses are intact
- 3Check the connector to the oil level sensor for contact resistance and oxidation; clean and remedy it if needed
- 4If you have a diagnostic tool, read the fault status with the ignition on and see whether the fault is still active
- 5If the fault remains after these checks, have a workshop with diagnostic equipment check the oil level sensor
Symptome, die Sie bemerken können1
- No noticeable symptoms for the driver
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.