VOLVO
ECM-U201200 - Car Configuration Parameter(s). General Failure Information. No sub type information
System
Motorsteuergerät (ECM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
5 ModelleS80 (2007–), V70 (2008–), XC60 (2009–), XC70 (2008–), XC90 (2003–)
Modelle nach Baujahr und Motor anzeigen (14)
- Volvo S80 (2007–)2007–2008Nur Motor: D5244T4, D5244T5
- Volvo S80 (2007–)2009Nur Motor: D5244T10, D5244T4, D5244T5
- Volvo S80 (2007–)2010Nur Motor: D4164T, D5244T10, D5244T14, D5244T19
- Volvo S80 (2007–)2011Nur Motor: D4164T
- Volvo V70 (2008–)2008Nur Motor: D5244T4, D5244T5
- Volvo V70 (2008–)2009Nur Motor: D5244T10, D5244T4, D5244T5
- Volvo V70 (2008–)2010Nur Motor: D4164T, D5244T10, D5244T14, D5244T19
- Volvo V70 (2008–)2011Nur Motor: D4164T
- Volvo XC60 (2009–)2009Alle Motoren außer: B6304T2
- Volvo XC60 (2009–)2010Nur Motor: D5244T10, D5244T14, D5244T16
- Volvo XC70 (2008–)2008Alle Motoren außer: B6324S
- Volvo XC70 (2008–)2009Nur Motor: D5244T4, D5244T5
- Volvo XC70 (2008–)2010Nur Motor: D5244T10, D5244T14, D5244T16
- Volvo XC90 (2003–)2013–2014Nur Motor: D5244T18, D5244T5
Was bedeutet der Fehlercode?
The engine control module (ECM) checks its own configuration ID against the signal setup that the CEM broadcasts on the CAN network. The modules on the network must share the same signal configuration ID to communicate. The code is set when the module's own ID differs from the one the CEM sends out, and the fault may be because the module is not intended for this car.
Mögliche Ursachen
- Incorrect configuration ID, because the module is not intended for the car, for example a used module with different software or hardware
- Open circuit in the CAN cables between the module and the central electronic module (CEM)
- Fault in the central electronic module (CEM)
Was Sie tun können
- 1Check whether the engine control module is a used module or has been replaced recently. Tell the workshop, since the module must be intended for this car.
- 2Read the fault codes in the central electronic module (CEM) and remedy any faults there first. Do not replace the CEM for a CAN fault unless troubleshooting shows an internal fault.
- 3Look for loose or chafed wires and connectors on the CAN network between the ECM and the CEM. Gently wiggle them to see whether the fault appears.
- 4If a module was replaced without new software being loaded, have a workshop download the correct software, as this requires programming.
Symptome, die Sie bemerken können2
- Cruise control cannot be engaged
- Red warning symbol and message in the display
Was der Fehler beeinflussen kann1
- The control module shuts itself off (bus-off)
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.