VOLVO
IEM-U000188 - High Speed CAN Communication Bus. Bus Signal / Message Failures. Bus off
System
Unbekanntes System / Herstellerspezifisch
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
1 ModellV60 (2011–)
Modelle nach Baujahr und Motor anzeigen (2)
Was bedeutet der Fehlercode?
The electric rear axle drive control module (IEM) sends or receives no messages on the HS-CAN, or sends incorrect messages. The causes are a break in one or both CAN wires in one section of the network, a software fault in the IEM, or an internal fault in the voltage converter (ISC). The control module stays switched off until the power supply has been broken and reconnected.
Mögliche Ursachen
- Break in one or both CAN wires in one section of the network
- Software fault in the electric rear axle drive control module (IEM)
- Internal fault in the voltage converter (ISC)
Was Sie tun können
- 1Have a workshop check the CAN cables in the part of the network where the break is suspected. High voltage systems may only be handled by qualified personnel
- 2If you have a diagnostic tool: read the fault codes in the other control modules on the CAN network, since they can show which part of the network is affected
- 3Do not carry out any work on the high voltage system yourself
- 4After the repair, switch the ignition off and on and check that the code is not stored again
Symptome, die Sie bemerken können4
- Text window and warning symbol with a text message
- Drive mode PURE disengages automatically or is unavailable
- Drive mode AWD disengages automatically or is unavailable
- Drive mode HYBRID: the combustion engine runs all the time or too often
Was der Fehler beeinflussen kann3
- The control module shuts itself off (bus-off)
- Electric propulsion is not possible
- Brake energy regeneration from the electric rear axle is not possible
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.