VOLVO
IGM-U000188 - High Speed CAN Communication Bus. Bus Signal / Message Failures. Bus off
System
Unbekanntes System / Herstellerspezifisch
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
1 ModellV60 (2011–)
Modelle nach Baujahr und Motor anzeigen (2)
Was bedeutet der Fehlercode?
The high voltage generator control module (IGM) communicates with the other control modules over HS CAN. The code is stored when incorrect messages are sent or received on HS CAN, or when contact with HS CAN is lost. The fault is only checked once the test has started at ignition on.
Mögliche Ursachen
- Open circuit in one or both CAN wires in part of the network
- Software fault in the IGM
- Internal fault inside the ISC voltage converter
Was Sie tun können
- 1Read out, clear the code and start the car to see whether it returns
- 2Have a workshop check chafed or pinched CAN wires and check that the connectors on HS CAN are fully engaged
- 3Have a workshop with diagnostic equipment measure on the CAN network and establish whether the fault lies in the wiring or in a control module
- 4The high voltage system may only be handled by a workshop; do not work on it yourself
Symptome, die Sie bemerken können5
- Warning symbol and text message in the display
- Warning about power supply problems from the alternator and charge regulator
- Charging of the high voltage battery while driving is absent, reduced or not working correctly
- High voltage battery is discharged or charges poorly
- HYBRID drive mode: the combustion engine is active all the time or too often
Was der Fehler beeinflussen kann3
- The control module switches itself off (bus-off) and stays off until the power supply has been disconnected
- The high voltage battery cannot be charged by the combustion engine
- When the power supply is reconnected, the control module tries to communicate again
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.