VOLVO
KVM-0004 - Remote control receiver. No communication
System
Keyless-Entry-Modul (KVM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
5 ModelleC30 (2007–2013), C30 Electric (2011–2013), C70 (2006–2013), S40 (2004–2013), V50 (2004–2013)
Modelle nach Baujahr und Motor anzeigen (5)
Was bedeutet der Fehlercode?
The keyless vehicle module (KVM) monitors the link to the remote keyless entry receiver, which picks up the key fob signals and handles the keyless functions. The code is stored when the module registers that the signal is incorrect. Because the receiver no longer responds correctly, the remote control stops working, and both the cabling and the receiver need checking.
Mögliche Ursachen
- Signal wire shorted to supply voltage
- Signal wire shorted to ground
Was Sie tun können
- 1Try locking and unlocking the car with the remote control to confirm the fault
- 2Check the power supply and ground wiring between the receiver and the CEM for open circuits and shorts to supply voltage or ground
- 3Reconnect the cables and connectors at the receiver and the CEM and make sure they are seated properly
- 4Switch the ignition on and check again. If the signal wire shows an open circuit or a short, trace that wire
- 5Have a workshop with diagnostic equipment check the communication and replace the module if no other fault is found
Symptome, die Sie bemerken können1
- The car cannot be operated with the remote control
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.