VOLVO
KVM-B10C424 - Right rear unlock pull switch. General Signal Failures. Signal stuck high
System
Keyless-Entry-Modul (KVM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
9 ModelleS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V60 Cross Country (2015–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Modelle nach Baujahr und Motor anzeigen (9)
Was bedeutet der Fehlercode?
The unlock pull switch on the right rear starts a timer when it is activated. If it has been activated for too long, meaning the signal stays high, the code is stored and unlocking of the door may be slow. The code does not say what type of fault it is, but it points to the switch, the handle or the wiring.
Mögliche Ursachen
- The right rear door handle has been held pulled out for an unusually long time
- The switch is damaged
- The signal wire has a short to ground
Was Sie tun können
- 1Read and note the code, clear it and road test the car to see whether it returns
- 2Check that the handle returns to its rest position and is not damaged or held by dirt or ice
- 3With a diagnostic tool, pull the handle out and release it, and watch the live-data switch value go from activated to inactive
- 4With the ignition off, use a multimeter to check that the wire from the switch is not in contact with ground (the body)
- 5Have a workshop replace the switch if the wiring is sound and the fault remains
Symptome, die Sie bemerken können1
- The door unlocks with a delay
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.